Interpretation ID: 2353y
Andreini & Company
770 The City Drive South, Suite 1300
Orange, CA 92668
Dear Mr. Higgins:
This responds to your letter on behalf of Skill-Craft Enterprises, which is designing and manufacturing a fiberglass seat to be installed in the bed of a pickup truck. You were interested in learning which of the Federal motor vehicle safety standards would apply to this product. You indicated that you believed Standards No. 207, 209, 210, and "possibly 302" would apply to this seat.
I am enclosing a December 1, 1986 interpretation letter from this office to Mr. Scott Muirhead, which explains the application of NHTSA's safety standards and regulations to seats in the cargo bed of a pickup. You will see that this letter specifically addresses the applicability of Standards No. 207, 208, 209, and 210 to such seats. I am also enclosing an information sheet for new manufacturers that briefly describes our laws and regulations, and explains how to get copies of those laws and regulations.
You also asked whether Standard No. 302, Flammability of Interior Materials, would apply to your client's product. That standard applies only to new vehicles in areas located in the "occupant compartment air space," which the standard defines as "the space within the occupant compartment that normally contains refreshable air." I am enclosing a copy of a February 15, 1983 interpretation to Mr. H. Nakaya in which the agency explained that the determination of whether any particular area is within the "occupant compartment air space" turns on whether people can and do ride in the area in question. Given that your client's product is a seat, it is designed and intended so that people will ride in it. Hence, the area around the seat would be an area where people could and would ride, and would be considered within the "occupant compartment air space." Section S4.1 of Standard No. 302 expressly lists seat cushions, seat backs, and seat belts as items of equipment that must meet the flammability resistance requirements of section S4.3. Based on the above, we conclude that a seat installed as original equipment in the bed of a pickup would be required to comply with Standard No. 302.
If the seat will be sold exclusively as an item of aftermarket equipment, Standard No. 302 would not directly apply to it. Nevertheless, other Federal laws indirectly affect your client's manufacture and sale of such a seat in the aftermarket. Section 108(a)(2)(A) of the Act states: "No manufacturer, distributor, dealer, or motor vehicle repair business shall knowingly render inoperative ... any device or element of design installed on or in a motor vehicle or item of motor vehicle equipment in compliance with an applicable Federal motor vehicle safety standard ..." This section requires manufacturers, distributors, dealers or motor vehicle repair businesses (i.e., any person holding him or herself out to the public as being in the business of repairing motor vehicles or motor vehicle equipment for compensation) to ensure that any aftermarket installations of additional equipment or vehicle modifications its addition would not negatively affect the compliance of any component or design on a vehicle with applicable Federal safety standards. Section 109 of the Act specifies a civil penalty of up to $1,000 for each violation of this "render inoperative" provision.
Your client should also be aware of an additional aspect of the Safety Act. As a manufacturer of motor vehicle equipment, your client is also subject to the requirements in sections 151-159 of the Safety Act concerning the recall and remedy of products with defects relating to motor vehicle safety. I have enclosed an information sheet that briefly describes those responsibilities. In the event that your client or NHTSA determines that the seats contain a safety related defect, it would be responsible for notifying purchasers of the defective equipment and remedying the problem free of charge.
If you have any further questions or need additional information on this subject, please feel free to contact Marvin Shaw of my staff at this address or by telephone at (202) 366-2992.
Sincerely,
Stephen P. Wood Acting Chief Counsel
Enclosures
/ref:302 d:2/l4/90