Interpretation ID: 2905yy
4405 Lafayette Street
Bellaire, TX 77401
Dear Ms. Flautt
This responds to your letter to Mr. Steve Kratzke of my staff, requesting that the National Highway Traffic Safety Administration (NHTSA) grant permission to a repair business to modify your motor vehicle.
You explained that you are under five feet, two inches and legally blind in one eye. You further explained that, due to the increased size of headrests in recent years, you are unable to locate a 1991 automobile which does not have headrests which impede your field of vision. You wish to arrange to have the size of the headrests in a 1991 automobile reduced. You asked if you could obtain permission from this agency to permit this modification. I hope the following discussion explaining our regulation will be of assistance to you.
I would like to begin by clarifying that there is no procedure by which persons petition for and are granted permission from NHTSA to arrange to have a motor vehicle repair business modify their motor vehicle. Repair businesses are permitted to modify vehicles without obtaining permission from NHTSA to do so, but are subject to certain regulatory limits on the type of modifications they may make. In certain limited situations, we have exercised our discretion in enforcing our regulations to provide some allowances to a repair business which cannot conform to our regulations when making modifications to accommodate the special needs of persons with disabilities. Since your situation is among those given special consideration by NHTSA, this letter should provide you with the relief you seek.
Our agency is authorized to issue Federal Motor Vehicle Safety Standards (FMVSS) that set performance requirements for new motor vehicles and items of motor vehicle equipment. Manufacturers are required by the National Traffic and Motor Vehicle Safety Act (Safety Act) to certify that their products conform to our safety standards before they can be offered for sale. Manufacturers, distributors, dealers and repair businesses modifying certified vehicles are affected by 108(a)(2)(A) of the Safety Act. It prohibits those businesses from knowingly rendering inoperative any elements of design installed on a vehicle in compliance with a FMVSS. In general, 108(a)(2)(A) would require repair businesses which modify motor vehicles to ensure that they do not remove, disconnect or degrade the performance of safety equipment installed in compliance with an applicable safety standard. Violations of 108(a)(2)(A) are punishable by civil fines up to $1,000 per violation.
In situations such as yours where a vehicle must be modified to accommodate the needs of a particular disability, we have been willing to consider any violation of 108(a)(2)(A) a purely technical one justified by public need. I can assure you that NHTSA would not institute enforcement proceedings against a repair business that modifies the headrest on your vehicle to accommodate your condition. We caution, however, that only necessary modifications should be made to the headrest to accommodate your condition and we urge your dealer to modify your vehicle in such a manner that would not degrade from the safety currently provided by your vehicle. Many manufacturers are currently installing headrests in vehicles which exceed the minimum dimensions required by FMVSS No. 202, Head Restraints. I urge you not to have your headrest reduced below these dimensions if it is not necessary for your field of view.
If you have further questions or need some additional information in this area, please contact Mary Versailles of my staff at this address or by telephone at (202) 366-2992.
Sincerely,
Paul Jackson Rice Chief Counsel
/ref:VSA, 202 d:3/26/9l