Interpretation ID: aiam1485
Product Safety Engineer
Volvo of America Corporation
Rockleigh
NJ 07647;
Dear Mr. Shue:#This is in reply to your letter of April 15, 1974, t Mr. Schneider requesting an interpretation of identification requirements of Standard No. 101 as it applies to your proposed 1975 headlamp switch identification plate.#The standard provides that a symbol may be used to identify the lighting control. Your plate would use three symbols to identify lighting control operational positions, a different matter. Therefore, your use of the plate is not prohibited by Standard No. 101.#In response to your other questions, as this agency has previously noted (36 F.R. 8296, May 4, 1971), the NHTSA intends the headlamp symbol to be representative only and 'A symbol resembling the one published, with as few as three rays of light, may be used. . . .' The beams of the headlamp symbol, however, must face in the direction shown in Table I, to the right of the lamp. We have proposed adoption of the ISO symbol in which the beams are to the left (38 F.R. 26940, September 27, 1973) but no action has been taken on the proposal.#Yours truly, Richard B. Dyson, Assistant Chief Counsel;