Skip to main content
Search Interpretations

Interpretation ID: aiam3483

Mr. T. Fumima, President, Taiyo Trading USA Inc., 1543 West Olympic Boulevard, Los Angeles, CA 90015; Mr. T. Fumima
President
Taiyo Trading USA Inc.
1543 West Olympic Boulevard
Los Angeles
CA 90015;

Dear Mr. Fumima: This responds to your letter of June 17, 1981, asking about th applicability of Federal motor vehicle safety standards to a manually operated door opener that you are considering importing. The door opener is designed for passenger cars and taxis and allows the driver to open the rear door by shifting a lever located by the driver's side.; By way of background information, the agency does not give approvals o vehicles or equipment. The National Traffic and Motor Vehicle Safety Act places the responsibility on the manufacturer to ensure that its vehicles or equipment comply with applicable requirements. A manufacturer then certifies that its vehicles or equipment comply with all applicable standards. We note that the term 'manufacturer' is defined by section 102(5) of the Act to mean 'any person engaged in the manufacturing or assembling of motor vehicles or motor vehicle equipment, *including any person importing motor vehicles or motor vehicle equipment for resale*.' Emphasis added. ; The agency does not have any regulations covering manually operate door openers. However, installation of such a device may affect a vehicle's compliance with other safety standards. If any standard would be affected, it would probably be Safety Standard No. 206, *Door Locks and Door Retention Components*. For your convenience, we have enclosed a copy of that standard, which includes performance requirements for a vehicle's latch and striker assembly, door hinges, and door locks. However, based on the limited drawings included with your letter, it is not possible for us to determine whether a vehicle's compliance with that standard would be affected. We suggest that you carefully examine the requirements of Standard No. 206 to make that determination.; If your device is added to a new motor vehicle prior to its first sale the person who modifies the vehicle would be an alterer of a previously certified motor vehicle and would be required to certify that, as altered, the vehicle continues to comply with all of the safety standards affected by the alteration. You will find the specific certification requirements for alterers at 49 CFR Part 567.7, *Certification*. On the other hand, you as the manufacturer of the device would have no certification requirements, because we have no safety standards applicable to your equipment. However, an alterer would probably require information from you in order to make the necessary certification.; If your device is installed on a used vehicle by a business such as garage, the installer would not be required to attach a certification label. However, it would have to make sure that it did not knowingly render inoperative the compliance of the vehicle with any safety standard. This is required by section 108(a)(2)(A) of the National Traffic and Motor Vehicle Safety Act, which states in relevant part:; >>>No manufacturer, distributor, dealer, or motor vehicle repai business shall knowingly render inoperative, in whole or part, any device or element of design installed on or in a motor vehicle or item of motor vehicle equipment in compliance with an applicable Federal motor vehicle safety standard.<<<; Please feel free to contact us if you have any further questions. Yo may also wish to check with state and local authorities to determine whether the use of your device is affected by their regulations.; Sincerely, Frank Berndt, Chief Counsel