Interpretation ID: aiam3865
President
Premier Crown Corp.
P.O. Box 30576
Umstead Industrial Park
Raleigh
NC 27622;
Dear Mr. Pomer: This responds to your letter requesting an interpretation of Federa Motor Vehicle Safety Standard No. 218, *Motorcycle Helmets*, as it relates to one of the Premier helmet models. You enclosed a photograph of the helmet which shows that the helmet has a visor in the front. You state that the visor is an integral part of the polycarbonate helmet shell and ask if this helmet complies with the standard.; This agency administers the National Traffic and Motor Vehicle Safet Act of 1966, 15 U.S.C. 1391 *et seq*. (as amended) (the Act). Certification that an item of motor vehicle equipment, such as a motorcycle helmet, complies with any applicable Federal motor vehicle safety standard is the obligation of the manufacturer under section 114 of the Act. For this reason, the National Highway Traffic Safety Administration (NHTSA) does not state in advance whether a helmet complies with the standard. The agency's determination of compliance occurs only in the context of an enforcement action.; This office has reviewed the photograph of the Premier helmet regardin the visor and notes that paragraph S5.4 of Standard No. 218 requires that: 'The brow opening of the helmet shall be at least 1 inch above all points in the basic plane that are within the angles of peripheral vision (see Figure 3).' The intent of this provision is to give the helmet user an unobstructed view. Therefore, if the lowest point, or the tip, of the visor is at least one inch above the basic plane, as shown in Figure 2 of the standard, the helmet should meet the requirements of this provision.; A copy of 49 CFR Part 556, *Exemption for Inconsequential Defect o Noncompliance, is enclosed for your information, if you decide to petition the NHTSA regarding the inconsequentiality of a noncompliance.; Sincerely, Jeffrey R. Miller, Chief Counsel