Interpretation ID: aiam5070
VA 23260-6283;
"Dear Mr. Owens: This responds to your letter requesting informatio regarding the legal aspects of school bus safety standards. Specifically, you requested a book or pamphlet containing the requested information. By way of background information, under the provisions of the National Traffic and Motor Vehicle Safety Act of 1966, 15 U.S.C. 1381 et seq. (Safety Act), the National Highway Traffic Safety Administration (NHTSA) is authorized to promulgate Federal motor vehicle safety standards that apply to the manufacture and sale of new motor vehicles, in order to reduce the number of fatalities and injuries that result from motor vehicle crashes. In 1974 Congress enacted the Motor Vehicle and Schoolbus Safety Amendments of 1974 which, by amending section 121 of the Safety Act, directed the issuance of motor vehicle safety standards on specific aspects of school bus safety, applicable to all school buses. Those standards became effective on April 1, 1977 and are included, along with the rest of the agency's safety standards, in 49 CFR Part 571. The Safety Act defines a school bus as a vehicle that 'is likely to be significantly used for the purpose of transporting primary, preprimary, or secondary school students to or from such schools or events related to such schools.' NHTSA further defines a school bus as a motor vehicle designed for carrying eleven or more persons, including the driver, and sold for transporting students to and from school or school-related events. See 49 CFR 571.3. It is a violation of Federal law for any person knowingly to sell as a school bus any new vehicle that does not comply with all applicable Federal school bus safety standards. On the other hand, once a vehicle has been sold to the first purchaser for purposes other than resale, it may be used to transport school children without violating Federal law, even though it may not comply with Federal school bus safety standards. That is because individual states have the authority to regulate the use of vehicles. Therefore, to ascertain whether one may use noncomplying vehicles to transport school children, one must look to state law. It is this agency's position that vehicles meeting Federal school bus safety standards are the safest way to transport school children. Please find enclosed a pamphlet issued by this agency entitled Federal Motor Vehicle Safety Standards and Regulations, which summarizes our safety standards. Specifically, the following standards include requirements for school buses: Standards 101 through 104, Standard 105 (school buses with hydraulic brakes) Standards 106 through 108, Standards 111 through 113, Standard 115, Standard 116 (school buses with hydraulic service brakes), Standards 119 and 120, Standard 121 (school buses with air brakes), Standard 124, Standard 131 (effective September 1, 1992), Standards 201 through 204 (school buses with a gross vehicle weight rating (GVWR) of 10,000 pounds or less), Standard 205, Standards 207 through 210, Standard 212 (school buses with GVWR of 10,000 pounds or less), Standard 217, Standard 219 (school buses with GVWR of 10,000 pounds or less), Standard 220, Standard 221 (school buses with GVWR greater than 10,000 pounds), Standard 222, Standards 301 and 302. Some of the above-listed standards have unique requirements for school buses, including, but not necessarily limited to, Standards 105, 108, 111, 217, and 301. Other standards are applicable only to school buses, such as Standards 131, 220, 221, and 222. Standard 131 was promulgated on May 3, 1991 and may be found at 56 Federal Register 20370. It requires all school buses manufactured after September 1, 1992, to be equipped with stop signal arms. Standard 220 establishes requirements for school bus rollover protection. Standard 221 establishes strength requirements for school bus body panel joints. Standard 222 establishes minimum crash protection levels for occupants of school buses. Under the provisions of Standard 222, small school buses, that is those with a GVWR of 10,000 pounds or less, must be equipped with lap belts. For large school buses, those with a GVWR greater than 10,000 pounds, the standard requires occupant protection through 'compartmentalization,' a concept which calls for strong, well-padded, well-anchored, high-backed, evenly spaced seats. Should you wish copies of our safety standards, I am enclosing for your information a fact sheet prepared by this office entitled Where to Obtain NHTSA's Safety Standards and Regulations. I hope this information is helpful. If you have further questions in this regard, please feel free to contact Mr. Walter Myers of my staff at this address or by telephone at (202) 366-2992. Sincerely, Paul Jackson Rice Chief Counsel Enclosures";