Interpretation ID: aiam5218
GA 30306;
"Dear Mr. Ross: This responds to your letter requesting informatio about a product that attaches to an automobile's back window. In a telephone conversation with Marvin Shaw of my staff, you stated that your product is a two to three inch high LED sign that extends along most of the rear window. The sign displays any message that the driver chooses. While we do not have information about State or local laws, I am pleased to have this opportunity to explain the applicability of Federal law on your product. By way of background information, NHTSA is authorized to issue Federal Motor Vehicle Safety Standards that set performance requirements for new motor vehicles and items of motor vehicle equipment. NHTSA does not, however, approve or certify any vehicles or items of equipment. Instead, the National Traffic and Motor Vehicle Safety Act ('Safety Act') establishes a 'self- certification' process under which each manufacturer is responsible for certifying that its products meet all applicable Federal motor vehicle safety standards (FMVSSs). In response to your question, NHTSA currently has no FMVSSs that directly apply to the product you wish to manufacture. I note, however, that there are other Federal requirements that indirectly affect you and your product. Under the Safety Act, your product is considered to be an item of motor vehicle equipment. As a manufacturer of motor vehicle equipment, you are subject to the requirements in 151-159 of the Safety Act concerning the recall and remedy of products with safety related defects. I have enclosed an information sheet that briefly describes those responsibilities. In the event that you or NHTSA determines that your product contains a safety-related defect, you would be responsible for notifying purchasers of the defective equipment and remedying the problem free of charge. Automotive accessory equipment that a dealer adds before sale of a vehicle must not create a noncompliance with the FMVSSs to which the vehicle manufacturer has certified compliance. For instance, your LED sign should be mounted so that it does not block the field of view required by FMVSS No. 111, Rearview Mirrors. Similarly, for the vehicle to remain in compliance, your system must not impair the effectiveness of the lighting equipment required by FMVSS No. 108, Lamps, Reflective Devices, and Associated Equipment. In particular, the placement of your sign might impair the effectiveness of the center highmounted stop lamp (CHMSL) if it can be operated simultaneously with the CHMSL or at a time when the turn signals are flashing. In addition, manufacturers, distributors, dealers, and motor vehicle repair businesses are subject to 108(a)(2)(A) of the Safety Act, which states: 'No manufacturer, distributor, dealer, or motor vehicle repair business shall knowingly render inoperative ... any device or element of design installed on or in a motor vehicle or item of motor vehicle equipment in compliance with an applicable Federal motor vehicle safety standard ....' It is conceivable that your product, when placed on a vehicle's rear window, could 'render inoperative' the vehicle's ability to comply with FMVSS No. 108 and FMVSS No. 111. Persons in the aforementioned categories that install your product must ensure that such installation does not render inoperative the safety protection provided by the applicable standards. Specifically, your product should be mounted so that it does not interfere with the CHMSL or turn signal lamps nor block the field-of-view required by FMVSS No. 111. The 'render inoperative' prohibition of 108(a)(2)(A) does not apply to the actions of vehicle owners in adding to or otherwise modifying their vehicles or items of motor vehicle equipment. Thus, if your product were placed on a rear window by the vehicle owner, then the render inoperative provision would not apply. Nevertheless, in the interest of safety, you should ensure that your product does not adversely affect a vehicle's rear lamps or rearward visibility. We are unable to advise you as to whether the laws of any State address this topic. You should consult the American Association of Motor Vehicle Administrators for an opinion. Its address is 4600 Wilson Boulevard, Arlington, Va. 22203. I hope you find this information helpful. If you have any other questions, please contact Marvin Shaw of my staff at this address or by phone at (202) 366-2992. Sincerely, John Womack Acting Chief Counsel Enclosure";