Interpretation ID: nht78-2.26

DATE: 04/05/78

FROM: AUTHOR UNAVAILABLE; M. M. Finkelstein; NHTSA

TO: C. S. Ullman

TITLE: FMVSS INTERPRETATION

TEXT: This is in reply to your letter of February 28, 1978, to Mr. A. P. Uccello, regarding Federal Motor Vehicle Safety Standard No. 202, Head Restraints (copy enclosed).

In this Standard, under section 4(b)(1), the minimum height of the head restraint shall not be less than 27.5 inches above the seating reference point which is determined with a three-dimensional H Point Machine per SAE Standard J826B placed on the seat. Thus, we have specified a minimum dimension that the car builder must comply with, but we have no limit on the maximum dimension of the head restraint. This latter dimension is set by the builder to suit his requirements.

Certainly your height is a problem in this case and for future rulemaking actions along this line we are placing your letter and the Buick reply in the appropriate docket.

SINCERELY,

February 28, 1978

A.P. Uccello Transportation Dept.

Dear Sir:

You are impossible to get on the phone so I will resort to writing.

I have nothing but plaudits for my '77 Buick but I have written to them about the height of the head restraint (head rests). I am 6' 7" tall and the head rest probably would not prevent whip lash in my case. Previously the head rest was made so it could lock in at least three positions-the highest position was correct for me. Now the head rest only tranerses about 1 inch and does not lock so people getting in the back seat could depress the head rest.

Enclosed please find copy of my reply from Buick. I call your attention to the second paragraph. I would like to know what safety standard effects the head rest? If there is such a standard, then it should be corrected.

I welcome your comment and advice.

THANK YOU.

Charles S. Ullmann

BUICK MOTOR DIVISION, GENERAL MOTORS CORPORATION January 31, 1978

S. C. Ullmann Associates, Inc. 94 Highland Road Scarsdale, NY 10583

Att: Mr. Charles S. Ullmann

Dear Mr. Ullmann:

Thank you for your recent note of January 23, 1978 addressed to our Zone Manager, Mr. R. G. Royer, and we appreciate the interest you have shown in bringing to our attention the characteristics of the front seat head rest supports in your 1977 Buick Electra Limited.

As you probably realize, your car was manufactured in compliance with many vehicle safety standards, and one of these considerations is the head rest suitability throughout the range and size of the car occupants.

However, since we welcome comments from all of our owners, it is with this thought that we are forwarding your letter to the attention of those parties responsible for these design caracteristics.

Thank you again for writing, and please be assured of our interest.

K. J. Mariano Manager, Zone Service Operations