Interpretation ID: nht94-1.68

TYPE: Interpretation-NHTSA

DATE: March 7, 1994

FROM: John Womack -- Acting Chief Counsel, NHTSA

TO: Lawrence A. Beyer

TITLE: None

ATTACHMT: Attached to letter dated 2/14/94 from Lawrence A. Beyer to Z. Taylor Vinson (OCC-9662)

TEXT:

This responds to your FAX of February 14, 1994, to Taylor Vinson of this Office regarding the "re-importation" of used certified motorcycles into the United States after modifications have been performed abroad. These modifications would not involve a " knowingly rendering inoperative" of equipment related to the Federal motor vehicle safety standards. You have asked whether our interpretation of November 16, 1992, "regarding this matter" remains operative.

We assume the letter to which you refer is the one addressed to Wolfgang Klamp of Blaine, Washington. Mr. Klamp's wife crossed the border daily in her Canadian-manufactured Ford Tempo to her Canadian place of employment. Because the vehicle was not cert ified as meeting U.S. safety standards, the U.S. Customs Service had informed her the car would not be admitted in the future without going through the formal entry process for conversion to the U.S. standards. We verified that the Customs Service was a cting in accordance with the National Traffic and Motor Vehicle Safety Act, and provided several suggestions.

This letter remains our position. However, we fail to understand its relevance to the fact situation you present regarding importation of motorcycles that are certified as meeting the Federal motor vehicle safety standards. We can only surmise that ind ividual Customs officials may be questioning whether the modified motorcycles comply with all applicable U.S. Federal motor vehicle safety standards at the time of entry, notwithstanding the fact that they are certified as complying as of their manufactu re. As you know, a motor vehicle offered for importation must comply with the U.S. safety standards at the time of importation (or be converted to those standards after entry), regardless of its state of compliance at the time of its manufacture.

We have no regulations under which a manufacturer, distributor, dealer, or motor vehicle repair business may state that it has not knowingly rendered inoperative any device or element of design installed in accordance with a Federal motor vehicle safety standard. However, we would recommend that Customs accept such a statement accompanying an HS-7 Form's declaration of vehicle compliance if it also contained the statement that in the modifier's opinion the vehicle remained in compliance upon completion of the modifications.

Alternatively, and relevant to modifications that relate to a safety standard which may not have had to be met initially (i.e. installation of glazing on a motorcycle that was not originally manufactured with a windshield), we suggest that the modifier p rovide a statement, in writing

or on a label affixed to the vehicle, of the kind required of an alterer of a new vehicle, as set forth in 49 CFR 567.7. This statement attests to the continuing compliance of a motor vehicle after modification. Our willingness to accept such a stateme nt should enable Customs to enter the modified motorcycles as conforming vehicles.