Interpretation ID: nht94-2.86

TYPE: INTERPRETATION-NHTSA

DATE: May 16, 1994

FROM: John Womack -- Acting Chief Counsel, NHTSA

TO: Fred Carr -- Engineer, Utilimaster

TITLE: None

ATTACHMT: Attached To Letter Dated 4/21/94 From Fred Carr To John Womack (OCC-9912)

TEXT: Dear Mr. Carr:

This responds to your question asking whether Federal Motor Vehicle Safety Standard No. 211, Wheel nuts, wheel discs, and hub caps, applies to "motor vehicle equipment relating to light duty, medium duty, and heavy duty trucks or truck manufacturers." As explained below, Standard No. 211 does not apply to trucks, or truck equipment.

S2. Application of Standard No. 211 states the following:

This standard applies to passenger cars, multipurpose passenger vehicles, and passenger car and multipurpose passenger vehicle equipment.

"Multipurpose passenger vehicle" is defined at 49 CFR @ 571.3 as a motor vehicle designed to carry 10 persons or less, which is constructed either on a truck chassis or with special features for occasional off-road operation. Since Standard No. 211 appl ies only to passenger cars, multipurpose passenger vehicles, and their equipment, Standard No. 211 does not apply to trucks, or truck equipment. "Truck" is defined at 49 CFR @ 571.3 as a motor vehicle designed primarily for the transportation of propert y or special purpose equipment. Accordingly, manufacturers of trucks or truck equipment are not required to certify their trucks and truck equipment to the requirements of Standard No. 211.

I hope this information is helpful. If there are any further questions, please contact Dorothy Nakama of my staff at (202) 366-2992.

Sincerely,