Interpretation ID: aiam2993
Assistant Manager
Safety and Legislation Department
U.S. Suzuki Motor Corporation
13767 Freeway Drive
Santa Fe Springs
California 90670;
Dear Mr. Petler: This is in response to your request of March 22, 1979, for a interpretation of Federal Motor Vehicle Safety Standard No. 109. First, I would like to apologize for the delay in responding to your request of September 14, 1978. As was explained to you in a telephone conversation on March 22, your letter and the response thereto was apparently lost when the Chief Counsel's offices were moved. Although we took great care to ensure that something like this would not happen, it seemingly did in this case. I regret this and hope that it has not caused any undue inconvenience for your company.; You asked whether it was permissible under Standard 109 for manufacturer to stamp the maximum permissible inflation pressure of a tire and its maximum load rating on the tire in both English units (pounds and psi) and metric units (kilograms and kPa). S4.3(b) and (c) of the standard specify that each tire shall have permanently molded onto the sidewalls the maximum load rating for the tire. This agency has interpreted this requirement to mean that the information must appear on the sidewalls in the English units, since this is the system of measurement which will be used and understood by most consumers. However, so long as the information appears in English units, there is no reason that it could not also be the additional information does not cause confusion about the required information. By stating not only the pressure and rating values, but also the units of value, your company would avoid causing any such confusion. Therefore, the expression of inflation pressure and load rating in English and metric units as shown in your illustration is permissible under Standard 109.; Sincerely, Frank Berndt, Acting Chief Counsel