Interpretation ID: 2253y
Senior Account Executive
Market Development
Fasson Specialty Division
250 Chester Street
Painesville, OH 44077
Dear Ms. Kent:
Thank you for your letter requesting an interpretation of whether the use of a product on motor vehicles would violate Standard No. 205, Glazing Materials (49 CFR /571.205). This product, called "Contra Vision," is designed to display messages or advertising materials on windows and other clear surfaces, so that viewers on one side of the clear surface will see the message displayed, while viewers on the other side of the surface will see an essentially transparent surface without any message visible. According to your letter, this product "will be used for promotional signage in store windows, but also has application in rear taxicab windows, as well as rear and side windows of city buses." You asked for our opinion of whether this product complies with Standard No. 205.
Some background on how Federal motor vehicle safety laws and regulation affect this product may be helpful. Our agency is authorized under the National Traffic and Motor Vehicle Safety Act to issue safety standards applicable to new motor vehicles and new items of motor vehicle equipment. NHTSA, however, does not approve or certify any vehicles or items of equipment, nor do we endorse any commercial products or processes. Instead, the Safety Act specifies that each manufacturer itself must certify that its products meet all applicable safety standards. The agency periodically tests vehicles and items of equipment for compliance with the standards, and also investigates alleged defects related to motor vehicle safety and alleged violations of other statutory provisions.
Your letter indicates that you are already aware that NHTSA has issued a safety standard that applies to the windows installed in motor vehicles. Specifically, Standard No. 205 requires that all new vehicles and all new glazing materials for use in motor vehicles must comply with certain performance requirements. Among the requirements set forth in Standard No. 205 are specifications for minimum levels of light transmittance. A minimum of 70 percent light transmittance is required in glazing areas requisite for driving visibility, which includes all windows in passenger cars. In trucks and buses, the windshield and windows to the immediate right and left of the driver and the rearmost window, if the latter is used for driving visibility, are considered to be requisite for driving visibility, and therefore subject to the 70 percent minimum light transmittance requirement.
Your letter did not provide any information on the light transmittance that would be measured through glazing with Contra Vision installed on it. The combination of the glazing material and the Contra Vision must allow at least 70 percent light transmittance to comply with the requirements of Standard No. 205. No manufacturer or dealer is permitted to install Contra Vision on the glazing materials on new vehicles, unless the manufacturer or dealer certifies that the vehicle continues to comply with the 70 percent minimum light transmittance and other requirements of Standard No. 205.
After a vehicle is first sold to a consumer, modifications to the vehicle are affected by section 108(a)(2)(A) of the Safety Act (15 U.S.C. 1397(a)(2)(A)). That section prohibits any manufacturer, dealer, distributor, or repair business from "rendering inoperative" any device or element of design installed in a vehicle in compliance with any safety standard. This provision of the law means that no manufacturer, dealer, distributor, or repair business could install Contra Vision if the addition of Contra Vision to the glazing would result in a light transmittance of less than 70 percent, or otherwise cause the vehicle to no longer comply with the applicable requirements of Standard 205. Violations of this "render inoperative" prohibition can result in Federal civil penalties to the manufacturer, dealer, distributor, or repair business of up to $1000 for each noncomplying installation.
Section 108(a)(2)(A) of the Safety Act does not affect vehicle owners. Hence, vehicle owners themselves may install Contra Vision or any other product on the glazing of their vehicle, regardless of whether the installation causes the vehicle to no longer comply with Standard No. 205. Individual States have the authority to regulate the operational use of vehicles by their owners, and, therefore, have the authority to regulate or preclude individual owner modifications to the glazing of their vehicles.
I have enclosed an information sheet that summarizes the relationship between Federal auto safety laws and motor vehicle window tinting. I hope this information is helpful. If you have any further questions or need any additional information about this topic, please feel free to contact Dorothy Nakama of my staff at this address or by telephone at (202) 366-2992.
Sincerely,
Stephen P. Wood Acting Chief Counsel
Enclosure ref:205#VSA d:l/9/90