Interpretation ID: 2402y
Dallas European Parts Distributors
1505 Wallace Drive
Carrollton, TX 75006
Dear Mr. Rowghani:
This is in reply to your letter of January 9, 1990, to Taylor Vinson of this Office. You have asked whether "importation and sale of European doors (without reinforcement bars) is in accordance with the rules and regulations of the Department of Transportation."
Your question appears premised upon the fact that many European passenger cars achieve compliance with Federal Motor Vehicle Safety Standard No. 214 Side Door Strength by being equipped with doors incorporating reinforcement bars. However, this standard applies only to new vehicles, and does not extend to replacement parts for such vehicles. Thus, if damage to a vehicle is such that its original door must be replaced, and that door incorporated a reinforcing bar, there is no requirement that the replacement door restore the vehicle to a condition in which it continues to meet Standard No. 214. In short, the importation and sale of a replacement door that does not incorporate a reinforcing bar does not violate any of the statutes, standards, or other regulations administered by this agency.
If the replacement door is intended for use on a passenger car line that is subject to the Federal Motor Vehicle Theft Prevention Standard that this agency administers, however, you should be aware that it must nevertheless be marked with the registered trademark of the manufacturer of the door, or unique identifier if there is no registered trademark, and the letter "R". I enclose a copy of the standard for your information, as this requirement is a relatively new one, and may not be clearly understood. This marking must be on the door before the door is imported into the United States.
Sincerely,
Stephen P. Wood Acting Chief Counsel
Enclosure (Part 541) ref:2l4#54l d:4/9/90