Interpretation ID: 2514y
1697 Latham
Birmingham, MI 48009
Dear Ms. Avis:
This responds to your letter to this agency asking about Federal regulations that apply to "an accessory seat pad" for booster seats and child restraint systems. I regret the delay in responding.
Your letter describes your product as a fabric seat cushion which is intended to provide comfort and head support to a child when the child is sleeping in the restraint system. You state that the cushion would be "held in place" on the seat with "the strap system inherent to the booster seat along with the weight of the child on the seat."
There is currently no Federal motor vehicle safety standard that is directly applicable to the product you wish to manufacture and sell. Our standard for child restraint systems (Standard No. 213) applies only to new systems and not to aftermarket components of a child restraint system, such as an aftermarket seat-pad.
However, there are other Federal laws that indirectly affect your manufacture and sale of the seat-pad. Under the National Traffic and Motor Vehicle Safety Act, your product is considered to be an item of motor vehicle equipment. As a manufacturer of motor vehicle equipment, you are subject to the requirements in sections 151-159 of the Safety Act concerning the recall and remedy of products with defects relating to motor vehicle safety. I have enclosed an information sheet that briefly describes those responsibilities. In the event that you or NHTSA determines that your seat-pads contain a safety related defect, you would be responsible for notifying purchasers of the defective equipment and remedying the problem free of charge.
If your product would be installed by commercial businesses instead of child seat owners, those businesses would have to do so in a manner consistent with section 108(a)(2)(A) of the Act. The provision states: "No manufacturer, distributor, dealer, or motor vehicle repair business shall knowingly render inoperative ... any device or element of design installed on or in a motor vehicle or item of motor vehicle equipment in compliance with an applicable Federal motor vehicle safety standard ..." Thus, this provision prohibits manufacturers, distributors, dealers or motor vehicle repair businesses (i.e., any person holding him or herself out to the public as in the business of repairing motor vehicles or motor vehicle equipment for compensation) from installing your seat-pad if the addition of your product would negatively affect the compliance of a child restraint with Standard 213 and if the installing business were aware of that effect.
There are elements of design incorporated in a child restraint system pursuant to Standard 213 that may be affected by installation of a seat-pad. For example, Standard 213 sets flame-retardant performance requirements for materials used in a child restraint system. (See paragraph S5.7 of Standard 213, referencing Standard 302, Flammability of Interior Materials (copy enclosed).) Installation of rapidly burning materials could vitiate the compliance of the child restraint with FMVSS No. 213. Section 109 of the Act specifies a civil penalty of up to $1,000 for each violation of 108.
In addition, Standard 213 sets crash protection requirements for all new child restraint systems. It is unclear from your letter whether the seat-pad has provision for passing the belt systems of a child restraint around or through the pad and cushion. If the installation of your seat-pad would impair the function of a belt installed to restrain the child, then any manufacturer, distributor, dealer, or motor vehicle repair business installing the seat-pad would likely be regarded as having knowingly rendered inoperative a Federally required element of design in child restraint systems, in violation of 108(a)(2)(A).
The prohibitions of 108(a)(2)(A) do not apply to the actions of a vehicle owner in adding to or otherwise modifying his or her vehicle or motor vehicle equipment. Nevertheless, this agency urges you to voluntarily ensure that your seat-pad would not render inoperative the crash protection and flammability resistance of any child restraint.
I hope this information is helpful. Please contact us if you have further questions.
Sincerely,
Stephen P. Wood Acting Chief Counsel
Enclosure
/ref:213 d:5/3l/90