Interpretation ID: 2901yy
2303 N. 44th Street, #14-237
Phoenix, AZ 80058
Dear Mr. Dembecki:
This responds to your letter of March 1, 1991, asking for an "evaluation" of your "Flashing' center stop lamp. You have four prototypes: "complete" one and two bulb units "for l984 and older vehicles", and one and two "electronic modules for all third safety brake light retrofits through 1991." In your opinion, "since the new safety brake light utilizes the existing brake light (retrofit) on a previously approved brake light assembly it is reasoned that any evaluation as to durability testing is not really needed."
We understand that your "complete" unit for the older vehicles is a lamp. It is unclear whether the "electronic module" intended for retrofit for newer vehicles is a separate lamp, or a device to be inserted into an existing lamp. However, the issue that your invention presents is not whether further testing of it is required, but whether it is permitted at all under applicable Federal statutes and regulations. We note that you would like to market it both for installation in passenger cars that already have a center lamp, and in those that do not. In short, you intend to sell the lamp/module in the aftermarket for installation on vehicles in use, rather than as original equipment installed by the manufacturer.
Center highmounted stop lamps have been required by Federal Motor Vehicle Safety Standard No. l08 on all passenger cars manufactured on or after September 1, l985 (effectively the l986 model year). You indicate that your lamp flashes momentarily when the brake pedal is applied and thereafter the lamp is steady-burning. Standard No. l08 initially allowed the center lamp to be wired so as to flash with the turn signals but, since September 1, l986, has required the center lamp to be steady-burning at all times when in use. Because your invention is not steady-burning at all times, and is activated by the brake pedal and not the turn signal control, the sale or installation of the invention may be prohibited by Federal law. If this invention is a lamp, it is not a center lamp that conforms to either the initial or current requirements of Standard No. l08 for center lamps. If, on the other hand, it is a module intended for insertion into an existing lamp, its sale or installation could violate existing Federal requirements.
The National Traffic and Motor Vehicle Safety Act forbids the sale of equipment that does not comply with a Federal motor vehicle safety standard. If your invention is sold as a lamp, and intended to replace original equipment center lamps on l986 and subsequent model year cars, its sale would be in violation of the Act. On the other hand, there is no similar prohibition on sale of componentry such as an electronic module that would create a noncompliance once installed. However, there is a prohibition on the installation of such componentry (as well as installation of the invention in lamp form on l986 and subsequent model year cars). The Act forbids a manufacturer, distributor, dealer, or motor vehicle repair business from rendering inoperative in whole or in part any equipment on a vehicle which has been installed pursuant to a Federal motor vehicle safety standard. We interpret this as forbidding the installation of equipment that would take a vehicle out of compliance with a Federal safety standard.
With respect to l985 model and older cars, which Standard No. l08 did not require to be equipped with center lamps, sale of your lamp exclusively for use on these older vehicles would not violate the Act. However, its installation remains subject to the rendering inoperative prohibition discussed above. There are other Federal standards involving equipment to consider. For example, we would be concerned if your lamp interfered with the field of view of the interior rear view mirror, and if its installation would affect the wiring of the other stop lamps so as to interfere with their design performance. However, there should be no problem with the field of view requirements if the lamp size is comparable to the required center lamps.
Once you have satisfied these concerns under Federal law, use of the lamp remains subject to the laws of the individual States in which it is used. We are unable to advise you on these laws, and suggest that you consult for an opinion the American Association of Motor Vehicle Administrators, 4600 Wilson Boulevard, Arlington, Va. 22203.
Sincerely,
Paul Jackson Rice Chief Counsel ref:l08 d:3/25/9l