Interpretation ID: 3298yy
Managing Director
Suzusho Trading Co.
Center Building No. 601
Fuchucho 1-12-7, Fuchu-shi
Tokyo, Japan
Your ref: ST-9015/91
Dear Mr. Suzuki:
This responds to your letter of October 16, l991, to the Director, Office of Public and Consumer Affairs, with reference to the "Safety Shot" lighting device that you have developed. You have enclosed photographs illustrating three types of this device in operation.
In brief, the device consists of a center red highmounted stop lamp, immediately flanked by amber lamps that serve as supplementary turn signal/hazard warning signal lamps. Although the photos are not entirely clear, the device appears to consist of segmented compartments in a common housing, with thicker dividers separating the signal and stop functions. Type I incorporates an L.E.D. and is mounted at the top of the rear window. Type II also incorporates an L.E.D. and is mounted at the bottom of the window. Type III is located at the top of the rear window and uses conventional bulbs for its light source. You have been referred to us by Chrysler Corporation. We assume that you approached Chrysler with a view towards having your device accepted as original motor vehicle equipment. You have asked for our views on whether it is possible to use this device in the U.S. market.
In the United States, the applicable Federal motor vehicle safety standard for rear lighting is Standard No. 108, Lamps, Reflective Devices, and Associated Equipment. Section S5.4 of Standard No. l08 does not allow a center high-mounted stop lamp to be physically combined with any other lamp or reflective device. Because Safety Shot appears to have a common housing for signalling and stopping functions, the lamps are "combined" within the meaning of the prohibition.
This means that the Safety Shot may not be used as original equipment on motor vehicles, and it may not be offered as a replacement for original equipment center highmounted stop lamps (required on each passenger car manufactured on or after September 1, l985). If you wish to sell the Safety Shot as an accessory in the aftermarket, for passenger cars manufactured before September 1, l985, different considerations apply. Installation of the Safety Shot by a manufacturer, distributor, dealer, or motor vehicle repair business is not permitted if it renders inoperative, in whole or in part, the function of any other rear lighting device.
The question, therefore, is whether the effectiveness of the function of any other rear lighting device is compromised by the Safety Shot to the extent that the other device's function is rendered, at the minimum, partially inoperative. We note that original equipment amber signal lamps are not prohibited from flashing when the stop lamps are operating. It would not appear that the addition of the Safety Shot to a passenger car manufactured before September 1, l985, would compromise the signals from the original turn signal and stop lamps in a manner to render them, at least, partially inoperative. However, the Safety Shot is subject to regulation by the individual States of the United States in which it is sold or used. We are unable to advise you on State laws, and suggest that you write for an opinion to American Association of Motor Vehicle Administrators, 4600 Wilson Boulevard, Arlington, Va. 22203.
Motor vehicles are also required to be manufactured to conform to Standard No. 111, Rearview Mirrors. Under this standard, if installation of the Safety Shot prevents the vehicle from meeting the rearview mirror field of view requirements specified, the manufacturer, distributor, dealer, or motor vehicle repair business installing the Safety Shot must install a rear view mirror on the passenger side of the vehicle (as a practical matter, most vehicles in the U.S. are manufactured with this additional mirror).
Sincerely,
Paul Jackson Rice Chief Counsel
ref:108 d:1/31/92