Interpretation ID: 6991

Mr. Charles Danis Les Enterprises Track Test Inc. 4652 Avenue Victoria Montreal, Quebec H3W 2N1 Canada

Dear Mr. Danis:

This responds to your letter about testing related to Federal motor vehicle safety standard No. 121, Air Brake Systems, (49 CFR 571.121). You explained that your company has recently conducted a compliance test on an articulated bus manufactured by MCI Greyhound Canada. According to your letter, the buses were tested using 28 psi for the brake actuation test and 40 psi for the brake release test. While these air pressures differ from the pressures specified in S5.3.3 and S5.3.4 for brake actuation and release times, you stated that MCI was relying on a July 23, 1976 interpretation issued by the agency to Mr. J.W. Lawrence of the White Motor Corporation that permitted such brake actuation and release pressures. We note that to be consistent with that interpretation, the maximum brake chamber pressure must have been 40 psi when the service reservoir pressure was at 100 psi. Your letter was not clear on that point. You asked whether this interpretation is still valid. As explained below, the answer is yes.

In its inquiry to NHTSA, White Motor Corporation asked whether S5.3.3 and S5.3.4 of Standard No. 121 require minimum brake chamber actuation and release time pressures of 60 psi and 95 psi, respectively, or whether these air pressures are included in the sections only as "bench marks" on which to base specifications for minimum actuation and release timing. In response, the agency's July 23, 1976 interpretation letter stated in relevant part that:

Your understanding that S5.3.3 and S5.3.4 only specify the air pressures of 60 psi and 95 psi as the basis for timing requirements is correct. Neither value is intended as a requirement that the vehicle be designed to provide a certain level of brake chamber air pressure. The values were based on an understanding of the typical configuration of existing air brake systems at the time the final rule was issued.

In response to your specific question, NHTSA's July 23, 1976 interpretation letter continues to be valid.

I hope this information is helpful. If you have any further questions about NHTSA's safety standards, please feel free to contact Marvin Shaw of my staff at this address or by telephone at (202) 366-2992.

Sincerely,

Paul Jackson Rice Chief Counsel Enclosure

Ref: 121 d:4/3/92