Interpretation ID: 7761
Bouhan, Williams & Levy
Attorneys and Counselors at Law
The Armstrong House
Bull & Gaston Streets
Post Office Box 2139
Savannah, GA 31498-1001
Dear Mr. Owens:
This responds to your letter dated September 15, 1992, to the Office of Vehicle Safety Standards, National Highway Traffic Safety Administration (NHTSA), regarding Phelps v. General Motors, et al. Reference is also made to your telephone conversation with Mr. Walter Myers of my staff on October 15, 1992.
You stated in your letter that your firm represents defendant Grumman Olson in the Phelps lawsuit which arose out of injuries suffered by the plaintiff while operating a 14-foot Grumman Kurbmaster manufactured in 1977. After explaining the theory of the plaintiff's cause of action, you stated that you have looked at current regulations, your main areas of interest being 49 CFR 571.201 through 571.220, and requested our assistance in obtaining those regulations from 1977. You pointed out that in those regulations there are a number of exceptions for walk-in vans, and you asked whether the 14-foot Kurbmaster would be considered a truck or a walk-in van, or both.
Please find enclosed, as requested, copies of 49 CFR 571.201 through 220 that were in effect as of October 1, 1977, duly certified as official Federal government documents to make them admissible in Federal court. As Mr. Myers explained to you by telephone, the cost for these copies, as certified, is $30.72. Pursuant to the provisions of 49 CFR Part 7, this charge represents one hour of search time at a cost of $22.22 per hour, plus copying fee of ten cents per page x 85 pages. Please remit a check in that amount, payable to Treasurer of the United States, to the National Highway Traffic Safety Administration, Office of Financial Management, Room 6134, 400 Seventh Street S.W., Washington, D. C. 20590. To ensure that your account will be properly credited, please annotate your check with "NCC-20."
Before responding to your question about the classification of the 14-foot Kurbmaster, a bit of background information is in order. The National Traffic and Motor Vehicle Safety Act of 1966, 15 U.S.C. 1381, et seq. (Safety Act), authorizes the National Highway Transportation Safety Administration (NHTSA) to issue Federal motor vehicle safety standards for new motor vehicles and items of motor vehicle equipment. All motor vehicles and items of motor vehicle equipment manufactured or imported for sale in the United States must comply with all applicable safety standards. In accordance with 49 CFR Part 567, Certification, manufacturers of motor vehicles and motor vehicle equipment must certify that their products comply with all such standards.
Motor vehicles are, and were as of 1977, classified according to six basic types: passenger cars, multipurpose passenger vehicles, trucks, buses, trailers, and motorcycles. Each type is defined in 49 CFR 571.3. Each safety standard applies to specified types of motor vehicles and/or motor vehicle equipment. Thus, manufacturers must first classify their vehicles in order to ascertain which safety standards apply and then certify that those vehicles meet all applicable standards. For that reason, NHTSA neither classifies vehicles nor does it approve or endorse any vehicle classification before the manufacturer has done so. NHTSA may, however, reexamine the manufacturer's classification during the course of enforcement proceedings. I note that, in the case of the 1977 14-foot Kurbmaster, there have been no enforcement proceedings.
The classification given the 1977 14-foot Kurbmaster by the manufacturer will be found on the certification label required by 49 CFR 567.4(a), and NHTSA has not reviewed or taken issue with that classification. Assuming it was classified as a truck, a truck was in 1977, and still is, defined in 49 CFR 571.3 as "a motor vehicle with motive power, except a trailer, designed primarily for the transportation of property or special purpose equipment."
As you noted in your letter, certain of the Federal motor vehicle safety standards exclude "walk-in vans" from their coverage. See, e.g., paragraph S2, Standard 203, Impact Protection for the Driver from the Steering Control System (49 CFR 571.203). The term "walk-in van" is commonly used and understood within the motor vehicle industry, and for many years the Federal motor vehicle safety standards did not include any definition of the term. I note, however, that in a recent rulemaking which extended Standard No. 214, Side Impact Protection, to light trucks, buses and multipurpose passenger vehicles, the agency added a definition of "walk-in van" to that standard. Effective September 1, 1993, Standard No. 214 defines "walk-in van" as "a van in which a person can enter the occupant compartment in an upright position." See S2.1.
I hope this information will be helpful to you. If you have any further questions, please feel free to contact Mr. Myers at this address or at (202) 366-2992.
Sincerely,
Paul Jackson Rice Chief Counsel
Enclosure
Ref:#571 d:11/10/92