Interpretation ID: 8056
Product Manager
Waekon Industries, Inc.
100 South Walnut Street
Kennett Square, PA 19348
Dear Mr. Ferver:
This responds to your letter asking about how this agency's regulations would apply to a product which you call the "Universal Replacement Fuel Cap." You explained that this product is designed to replace lost fuel caps until the proper replacement can be obtained. I am pleased to have this opportunity to explain our regulations to you. I am also enclosing a copy of a fact sheet entitled "Information for New Manufacturers of Motor Vehicles and Motor Vehicle Equipment."
By way of background information, NHTSA is authorized to issue Federal Motor Vehicle Safety Standards that set performance requirements for new motor vehicles and items of motor vehicle equipment. NHTSA is not authorized to certify or approve motor vehicles or motor vehicle equipment for compliance with the Federal Motor Vehicle Safety Standards. Instead, under the National Traffic and Motor Vehicle Safety Act, each manufacturer of a motor vehicle or item of motor vehicle equipment is responsible for certifying that its products meet all applicable safety standards.
There is currently no Federal Motor Vehicle Safety Standard that is directly applicable to a replacement fuel cap. Nevertheless, you should be aware of Safety Standard No. 301, Fuel System Integrity, which may be relevant to your product. Standard No. 301 applies only to new motor vehicles and specifies performance requirements that must be met by the fuel system as a whole following crash tests. The standard does not apply to individual components of a fuel system or to aftermarket equipment for use on fuel systems.
Although Standard No. 301 would not directly apply to a replacememt fuel cap, there are responsibilities under Federal law of which you should be aware. Manufacturers of motor vehicle equipment, which includes fuel caps, are subject to the requirements in sections 151-159 of the Safety Act concerning the recall and remedy of products with defects relating to motor vehicle safety.
In addition, there are prohibitions against certain modifications of new and used vehicles. Section 108(a)(2)(A) of the Safety Act specifies that no manufacturer, distributor, dealer, or motor vehicle repair business shall knowingly render inoperative any device or element of design installed on or in a new or used motor vehicle in compliance with any applicable Federal Motor Vehicle Safety Standard. Therefore, no person in any of the aforementioned categories may place your fuel cap on a motor vehicle if by so doing the vehicle's compliance with Standard No. 301 were negatively affected. Whether your fuel cap could be installed on a vehicle by a person in one of those categories without taking the vehicle out of compliance with Standard No. 301 or any other applicable Federal safety standard is a determination that must be made by the entity making the installation.
Please note that the prohibition of 108(a)(2)(A) does not apply to individual vehicle owners who alter their own vehicles. Thus, under Federal law, a vehicle owner may install or remove any item of motor vehicle equipment regardless of its effect on compliance with the Federal safety standards. However, the agency encourages vehicle owners not to remove or otherwise tamper with vehicle safety equipment if the modification would degrade the vehicle's safety.
We suggest that you also contact the Environmental Protection Agency to see whether EPA has any type of emissions standard that might affect you as the manufacturer of a fuel cap. The general telephone number for EPA is (202) 382-2090.
I hope this information is helpful. If you have any further questions about NHTSA's safety standards, please feel free to contact Marvin Shaw of my staff at this address or by telephone at (202) 366-2992. Sincerely,
John Womack Acting Chief Counsel
Enclosure ref:301 d.2/1/93