Interpretation ID: 86-4.17

TYPE: INTERPRETATION-NHTSA

DATE: 07/18/86

FROM: ERIKA R. JONES -- CHIEF COUNSEL NHTSA

TO: ROGER WILLIAMS -- PRESIDENT TECHNICAL HALLMARK ENTERPRISES, INC.

TITLE: NONE

ATTACHMT: UNDATED LETTER FROM ROGER WILLIAMS TO NHTSA

TEXT: Dear Mr. Williams:

This is in reply to your letter asking about regulations applicable to the "new lights that are now being seen on the trunk lids, and the rear windows of new automobiles".

The specific legal name for this light is "center high-mounted stop lamp". It was optional for use as original equipment on passenger cars manufactured between August 1, 1984 and September 1, 1985. It has been mandatory original equipment since then. The Federal regulation that requires it is Federal Motor Vehicle Safety Standard No. 108 Lamps, Reflective Devices, and Associated Equipment issued by the National Highway Traffic Safety Administration of the Department of Transportation. This standard specifies color, minimum illuminated lens area, mode of operation, etc. for original equipment, and for equipment intended to replace that original equipment. The standard does not cover center high-mounted stop lamps intended for use on cars that never had them, and a manufacturer of such aftermarket motor vehicle equipment is subject only to State laws on their design, installation, and use. We encourage aftermarket manufacturers to follow the Federal standard so that the full potential of the lamp may be realized. This means that the lamp should be steady-burning rather than pulsating, and that the lens not have logos, trademarks, or other markings on it to interrupt the transmission of light from the lamp. The standard does not specify the shape of the lamp but virtually all to date have been rectangular (photos of the 1987 Cadil ac Allante show a circular one), and some have exceeded the minimum requirement of a lens area of at least 4 1/2 square inches.

Noting your interest as a prospective manufacturer of these devices, I enclose a copy of Standard No. 108. Sections 4.1.1.41 (page 218), Section 4.3.18 (page 227) and Table III (page 256) provide the relevant requirements for center high-mounted stoplamps. Should you proceed to

manufacture aftermarket lamps, you would be subject to the agency's notification and remedy procedures should a safety related defect occur in them. Otherwise, you would appear to be subject only to State laws.

Sincerely,

ENCLOSURE