Interpretation ID: 9495
Quality Assurance Test Specialist
Century Products Company
9600 Valley View Road
Macedonia, OH 44056
Dear Mr. McGlothan:
This responds to your letter to me about the head impact protection and protrusion limitation requirements of Federal Motor Vehicle Safety Standard (FMVSS) No. 213, Child Restraint Systems. We received under separate cover the three child seats you sent for illustration purposes, samples of Models 4560, 4590 and the STE 1000.
You discuss in your letter a new method you would like to use to attach the head impact protection foam to the child restraint shell. The foam would be attached to the shell by means of two push-in pins, each 1/2 inch in length and with a 3/4 inch diameter head, as distinguished from the padding being glued to the shell as in the past. You stated that this change would better secure the foam padding to the shell and help your manufacturing process. You asked us whether the new method would meet the head impact protection requirement of S5.2.3 (for restraints recommended for children weighing less than 20 pounds) and the protrusion limitations of S5.2.4.
As you know, the National Traffic and Motor Vehicle Safety Act establishes a self-certification system under which manufacturers are responsible for ensuring that their products comply with all applicable FMVSSs. We do not approve, endorse, or give assurances of compliance of any product. NHTSA may examine the manufacturer's certification in the course of any enforcement action. In response to manufacturers' requests for interpretations of the FMVSS's, we try, to the extent possible, to provide information that will help them make their determinations of compliance. However, these responses are based on information provided by the manufacturer, and is subject to the findings of actual compliance testing by the agency. Should the agency, in the future, examine production units of these models and detect an apparent noncompliance or defect, those results will control.
You first inquire, "Please advise as to compression deflection," which we understand as asking whether S5.2.3.2 would permit you to secure the foam with the pins. We cannot tell you whether the foam padding would satisfy S5.2.3 of Standard 213. The compression deflection resistance and thickness of the material can only be determined in a compliance laboratory, using the laboratory procedures described in the standard. S5.2.3.2 states that each system surface, except for protrusions that comply with S5.2.4, which is contactable by a dummy head must be covered with slow recovery, energy absorbing material with specified characteristics. As explained in the next paragraph, the pins we examined appear to satisfy S5.2.4. Further, the pins might not be contactable by the dummy head in Standard 213's dynamic test. However, whether they are contactable can only be determined in the standard's dynamic test.
S5.2.4 requires that any portion of a rigid structural component within or underlying a contactable surface, or any portion of a child restraint system surface that is subject to S5.2.3 shall meet specified limits on height and radius of exposed edge. Based on our visual inspection, the pins we saw appear to be within those limits. Again, however, the Vehicle Safety Act places the responsibility for determining compliance in the first instance on you, the manufacturer of the child restraint.
We still have the three seats that you sent us. We plan to dispose of them unless we hear from you.
I hope this information is helpful to you. Should you have any further questions or need further information, please feel free to contact Walter Myers of this office at this address or at (202) 366-2992.
Sincerely,
John Womack Acting Chief Counsel
ref:213 d:4/8/94