Interpretation ID: nht78-4.5

DATE: 05/10/78

FROM: AUTHOR UNAVAILABLE; Joseph J. Levin Jr.; NHTSA

TO: The Barbour House

TITLE: FMVSR INTERPRETATION

TEXT: This responds to your January 12, 1978, letter asking several questions concerning the applicability of the Federal safety standards to vehicles that are being reconstructed with new chassis. The answers to your specific questions are set forth below.

1. You ask whether the replacement of the engine, transmission, drive train, rear end, frame, front axle, front brakes, wheels, and steering box constitutes the manufacture of a new chassis requiring a new or upgraded body. The answer to your question is yes. Part 571.7(e) of Volume 49 of the Code of Federal Regulations specifies the items that must be retained in a truck chassis in order that such chassis be considered used. These same considerations apply to reconstructed school buses since they are built on truck chassis.

2. You ask what parts of a chassis must be retained to ensure that the vehicle could continue to utilize an old body that does not comply with current Federal safety standards. Part 571.7(e) states that, at a minimum, the engine, transmission, and drive axle(s) must be retained.

3. You ask who must certify a remanufactured vehicle if its chassis is considered old or new. In the case of an old chassis that retains the required components and is therefore considered used, no certification is required of any repair business. In the case of a remanufactured chassis, the chassis manufacturer must certify his chassis for compliance and the shop that installs the body must certify the final compliance of the vehicle.

4. Part 568.8 states that vehicles altered before the first purchase for purposes other than resale must be labeled with an alterer's label. When a new chassis is installed in a vehicle, this is not an alteration, but rather, it is the manufacture of a new motor vehicle. Therefore, section 568.8 would not apply. The other provisions of Part 568 relating to the manufacture of a new motor vehicle would apply to this reconstructed vehicle. The person undertaking the remanufacture would be treated like the original manufacturer of the vehicle and would be required to certify it for compliance with the standards.

5. Standards promulgated after 1975 that are specifically applicable to school buses are: Standard No. 217-76, Bus Window Retention and Release, Standard No. 220, School Bus Rollover Protection, Standard No. 221, School Bus Body Joint Strength, Standard No. 222, School Bus Passenger Seating and Crash Protection, and Standard No. 301-75, Fuel System Integrity. Many of the other safety standards apply to school buses as well as other vehicles. I am enclosing a sheet detailing the applicability of Federal safety standards. All Federal safety standards are located in Volume 49 of the Code of Federal Regulations, Part 571. By examining the standards in Part 571, you can ascertain when their most recent amendment has occurred.