Interpretation ID: nht88-2.75

TYPE: INTERPRETATION-NHTSA

DATE: 07/18/88 EST

FROM: ERIKA Z. JONES -- CHIEF COUNSEL, NHTSA

TO: GARY EVANS -- PRESIDENT, WESTEX AUTOMOTIVE CORPORATION

TITLE: NONE

ATTACHMT: MEMO DATED 2-26-88, TO NHTSA, FROM GARY EVANS-WESTEX

TEXT: This is a response to your letter of February 26, 1988, where you asked the National Highway Traffic Safety Administration (NHTSA) whether a product you wish to import and sell in the United States "complies with any standards which may affect it.". You describe the product as a warning triangle that is designed to be attached to the side window of a car. You tell us that this side-mounted triangle is about 20% smaller than the warning device specified in this agency's regulations in Standard 125, War ning Devices. The answer to your question is that the device you described would not comply with Standard 125.

Standard 125 sets uniform specifications for warning devices. Paragraph S3 of Standard 125 states that the standard "applies to devices, without self-contained energy sources, that are designed to be carried in motor vehicles, and used to warn approachi ng traffic of the presence of a stopped vehicle, except for devices designed to be permanently affixed to the vehicle." By its own terms, then, Standard 125 applies to all warning devices that are not designed to be permanently affixed to the vehicle. Y ou are mistaken in suggesting that because the device attaches to the vehicle, Standard 125 is inapplicable. As I understand your description, the device is not "permanently affixed" to the vehicle. Rather, it is carried in the vehicle, and the vehicle operator may attach or remove the device as necessary. Therefore, this device is subject to the requirements of Standard 125.

According to your letter, this device fails to comply with the minimum size requirements set forth in paragraph S5.2.2 of Standard 125. Section 108(a)(1)(A) of the National Traffic and Motor Vehicle Safety Act (15 U.S.C. 1397(a)(1)(A)) specifies that, " No person shall . . . import into the United States any . . . item of motor vehicle equipment manufactured on or after the date any applicable Federal motor vehicle safety standard takes effect unless it is in conformity with such standard . . ." Standar d 125 took effect on January 1, 1974. Thus, Federal law prohibits you from importing any of the devices described in your letter that were manufactured on or after January 1, 1974.

I hope you find this information helpful. If you have further questions, please contact Joan Tilghman of my staff at (202) 366-2992.