Interpretation ID: nht93-6.15

DATE: August 16, 1993

FROM: John Womack -- Acting Chief Counsel, NHTSA

TO: Ron Marion -- Sales Engineer, Thomas Built Buses, Inc.

TITLE: None

ATTACHMT: Attached to letter dated 7/2/93 from Ron Marion to Marvin Shaw (OCC 8838)

TEXT:

This responds to your inquiry about the applicability of Standard No. 131, School Bus Pedestrian Safety Devices, to school buses you wish to sell to a customer in the United States Virgin Islands. You stated that these buses will be built as right hand drive vehicles with the entrance door located on the left side, since vehicles are driven on the left side of the road in this jurisdiction. You asked whether you can install, on the right side of the bus, the stop signal arm that is required by FMVSS 131. The answer is yes.

The National Traffic and Motor Vehicle Safety Act (15 U.S.C. S 1381, "Safety Act") requires new school buses sold in this country and in the U.S. Virgin Islands to comply with all applicable Federal school bus safety standards. (See, 15 U.S.C. S 1391(8) for reference to the Virgin Islands.) Standard No. 131 requires school buses to be equipped with a stop signal arm "on the left side of the bus." (S5.4) The purpose of this standard is "to reduce deaths and injuries by minimizing the likelihood of vehicles passing a stopped school bus and striking pedestrians in the vicinity of the school bus." (S2)

When NHTSA specified that the stop arm must be placed on "the left side of the bus," the agency meant the driver's side. Comments to the notice of proposed rulemaking (NPRM) and preamble of NHTSA's final rule all assumed that the left side of the bus meant the driver's side. (56 FR 20363, 20367). For example, while endorsing the proposed requirement for the stop arm, several commenters stated that an arm is needed near the driver's window. Moreover, S5.4.1(b) states that, for locating the arm, "the top edge of the stop signal arm is parallel to and not more than 6 inches from a horizontal plane tangent to the lower edge of the frame of the passenger window immediately behind the driver's window." (Emphasis added).

This provision indicates that the agency assumed that the "left" side is the driver's side. Further, a stop arm would not be needed on the non-traffic side of the vehicle.

Since the left side is not the driver's side for the school buses in question, the agency's general assumption was incorrect. In light of your letter, we will issue a technical amendment of Standard 131 so that S5.4 will require the stop signal arm on the DRIVER'S side of the bus. Until the amendment is issued, we will not take enforcement action regarding a manufacturer's locating a right hand drive school bus with a stop signal arm on the bus's driver's side.

I hope this information is helpful. If you have any questions about NHTSA's safety standards, please feel free to contact Marvin Shaw at this address or by telephone at (202) 366-2992.