Interpretation ID: nht94-7.18

DATE: March 28, 1994

FROM: John Womack -- Acting Chief Counsel, NHTSA

TO: Thomas D. Turner -- Manager, Engineering Services, Blue Bird Body Company

TITLE: None

ATTACHMT: Attached to letter dated 2/21/94 from Thomas D. Turner to John Womack (OCC 9719)

TEXT:

This responds to your letter of February 21, 1994, requesting further clarification of the requirements of S5.5.3(c) of Standard No. 217, Bus Emergency Exits and Window Retention and Release (as amended at 57 FR 49413; November 2, 1992). Section S5.5.3(c) states that "(e)ach opening for a required emergency exit shall be outlined around its outside perimeter with a minimum 3 centimeters wide retroreflective tape." *1 Your letter referenced our July 7, 1993 letter to you in which we stated that S5.5.3(c) permits interruptions in the tape necessary to accommodate curved surfaces and functional components. You requested confirmation "that retro-reflective tape around the perimeter of the rear of a school bus can be used to satisfy the requirements of S5.5.3(c)."

I cannot interpret the requirements of S5.5.3(c) as you request, since for many, if not most, designs the nearest possible location will be closer than the perimeter of the bus. While we appreciate your concerns about durability if numerous cuts or notches are made to accommodate rivets, our July 7 letter stated that manufacturers have the option of placing the retroreflective tape immediately adjacent to the rivets, rather than over the rivets. As an example, from the illustrations you enclosed, it appears that it may be possible to apply retroreflective tape outside the rivets adjacent to the lower portions of the door. Thus, that would be the nearest possible location, rather than the perimeter of the bus itself. I note, however, that the illustrations do not provide sufficient detail of all obstructions for us to determine the nearest possible location for each design.

I also note that your letter stated in support of your request that all school buses are required to have a rear emergency exit. While this is true, the type of emergency exit will vary and retroreflective tape at the perimeter of the exit would allow rescuers to immediately know the precise location of the exit. Moreover, retroreflective tape at the perimeter would enable rescuers to immediately know which type of exit is in this location. This information could be vitally important. Because push-out windows are not required to have a means of releasing the exit from outside the bus (S5.3.3.2), this information would allow rescuers to quickly determine that they should move to the sides of the bus to locate an exit they can open.

Your letter asked the agency to treat it as a petition for rulemaking if we did not interpret the standard as you requested. You will be notified of our decision to grant or deny your petition.

I hope you find this information helpful. If you have any other questions, please contact us at this address or by phone at (202) 366-2992.

*1 The July 7, 1993 letter also stated that the agency planned to issue a correction notice of the November 2, 1992 rule that would specify a minimum size of 2.5 cm for the tape. This notice has not yet been published. Until the correction is issued, NHTSA will not take enforcement measures regarding tape size against a manufacturer who uses 1 inch wide retroreflective tape.