Pasar al contenido principal
Search Interpretations

Interpretation ID: aiam0128

Mr. H.F. Barr, Vice President, General Motors Engineering Staff, General Motors Technical Center, Warren, Michigan 48090; Mr. H.F. Barr
Vice President
General Motors Engineering Staff
General Motors Technical Center
Warren
Michigan 48090;

Dear Mr. Barr: This will acknowledge your letter of October 23, 1968, requesting th addition of the 5-inch alternative rim size for use with the 155-13/6.15-13 tire size designation.; In your request you cited a letter from the German Rubber Industr stating that 'for passenger car tires in addition to the rim specified in the German Industrial Standards (DIN) also the use of the next large size rims is permissible.' The subject of the foot note in the German standard was discussed by my staff in conversations with Mr. Von Polhemus. When the Federal Motor Vehicle Safety Standards were written, it was the intent to accept the German Industrial Standards (DIN) of 1967 for all tire and rim combinations listed based on established usage. We did not intend to apply foot notes from any 1967 reference materials to the present or future tire and rim combinations.; However, on the basis of the data submitted indicating compliance wit the requirements of Federal Motor Vehicle Safety Standards No. 109 and No. 110 and other information submitted in accordance with the procedural guidelines set forth in the *Federal Register,* Volume 33, No. 195, page 14969, dated october 5, 1963, the 5J alternative rim size for the 155-13/6.15-13 tire size designation will be listed within Table I of Appendix A to Standard No. 110. This change will be published in the *Federal Register* in the near future.; The addition on this new alternative rim size to the table i accomplished through an abbreviated procedure consisting of the publication in the Federal Register of the petitioned alternative rim size. If no comments are received, the amendment becomes effective after 30 days from the date of publication. If comments objecting to amendments are received, additional rule making pursuant to Part 216 of Procedural Rules for Motor Vehicle Safety Standards will be considered.; Sincerely, H.M. Jacklin, Jr., Acting Director, Motor Vehicle Safet Performance Service;