Interpretation ID: aiam2477
Department of Police
Detroit
MI 48226;
Dear Mr. Papelian: This is in response to your letter of November 9, 1976, asking whethe Federal regulations permit manufacturers to equip police vehicles with 'push bumpers' and with bullet-proof shields located between the front and rear seating compartments.; Standard No. 215, *Exterior Protection*, establishes requirements fo the impact resistance and the configuration of front and rear vehicle surfaces of passenger cars. This standard does not prohibit 'push bumpers' and manufacturers are free to equip passenger cars with any bumper design they choose as long as the requirements of Standard No. 215 are met.; Standard No. 205, *Glazing Materials*, specifies requirements fo glazing for use in motor vehicles, including the permissible locations for the various types of glazing. The standard permits bullet-resistant glazing to be used anywhere in a motor vehicle, provided such glazing meets specified performance requirements. Therefore, vehicle manufacturers are permitted to equip vehicles with the bullet-proof shields mentioned in your letter if such shields are constructed with glazing that conforms to the requirements in Standard No. 205.; You also asked whether the police department or a business coul install the equipment in question. If the equipment is installed after the first sale of the vehicle for purposes other than resale, the Federal safety standards would no longer be applicable under the National Traffic and Motor Vehicle Safety Act (15 U.S.C. S 1397(b)(1). However, S 108(a)(2)(A) prohibits, with one exception, manufacturers, distributors, dealers, and motor vehicle repair businesses from knowingly rendering inoperative a safety device or element of design that has been installed in compliance with a motor vehicle safety standard.; Therefore, whether or not a business could install the equipmen depends on the nature of the business. If the business is a 'motor vehicle repair business', it can only install the 'push bumpers' and shields if such installation does not knowingly render inoperative devices or elements of design installed in the vehicle in compliance with applicable safety standards. Section 108(a)(2)(A) defines 'motor vehicle repair business' as any person who holds himself out to the public as in the business of repairing motor vehicles or motor vehicle equipment for compensation.; I have enclosed copies of Standard No. 205 and Standard No. 215. I hav underscored the pertinent sections of Standard No. 205 (and the ANS Z26 standard incorporated by reference in Standard No. 205) for your information.; Sincerely, Frank A. Berndt, Acting Chief Counsel