Interpretation ID: 3245yy
Senior Transportation Engineer
Franchise Regulation Division
City of Los Angeles Department of
Transportation
Room 1200, City Hall
Los Angeles, CA 90012
Dear Mr. Willis:
This responds to your letter concerning the installation of safety shields in 1982 model year and newer taxicabs. According to your letter, the City of Los Angeles plans to require the safety shields in order to deter or prevent crimes against taxicab drivers. The safety shields would be of a bullet resistant design (1/2" thick General Electric "LEXGUARD" or equivalent) complete with side panels, seat back protection and pass-through fare box. You asked whether any safety standards apply to such safety shields. I appreciate the opportunity to explain our regulations to you.
One Federal motor vehicle safety standard, Standard No. 205, Glazing Materials, applies directly to interior partitions such as taxicab safety shields, if the partition contains glazing material. The glazing used in taxicab safety shields, including ones that are installed on used vehicles, must meet the requirements of that standard.
In addition, the installation of a safety shield might affect the compliance of a vehicle with a number of other safety standards, including Standard No. 111, Rearview Mirrors, Standard No. 201, Occupant Protection in Interior Impact, Standard No. 202, Head Restraints, and Standard No. 208, Occupant Crash Protection. If a new vehicle is altered by the installation of a safety shield prior to the vehicle's first sale to a consumer, the person making the installation is required by 49 CFR Part 567, Certification, to certify that the vehicle complies with all safety standards affected by the alteration.
After the first sale to a consumer, a vehicle is no longer required by Federal law to conform to all safety standards. However, section 108(a)(2)(A) of the Safety Act provides as follows: No manufacturer, distributor, dealer, or motor vehicle repair business shall knowingly render inoperative, in whole or part, any device or element of design installed on or in a motor vehicle or item of motor vehicle equipment in compliance with an applicable Federal motor vehicle safety standard . . . .
In order to avoid violating this provision, a manufacturer, dealer, distributor, or repair business which installs a safety shield should ensure, by carefully comparing the safety shield and its planned installation with the requirements of relevant safety standards, that such installation enables the vehicle to continue to comply with all applicable safety standards. Violations of 108(a)(2)(A) are punishable by civil fines of up to $1,000 per violation. I note that section 108(a)(2)(A) does not affect modifications made by vehicle owners to their own vehicles.
I hope you find this information helpful. If you have any questions or need further information, please contact Edward Glancy of my staff at this address or by telephone at (202) 366-2992.
Sincerely,
Paul Jackson Rice Chief Counsel ref:VSA#201#205 d:l2/l6/9l