Interpretation ID: 7434
774 Harbor Island
Clearwater, FL 34630
Dear Mr. Welker:
This responds to your letter about a mirror system designed to improve a driver's view of areas behind a motor vehicle. You explained that a 35" vertical post would be bolted near a vehicle's rear bumper. This would result in a mirror being located a few inches above the top rear window stop light and facing forward at a 45 angle. You asked whether such a device would be legal. The following discussion and the enclosed information sheet, "Information for New Manufacturers of Motor Vehicles and Motor Vehicle Equipment," explain your responsibility under NHTSA's regulation.
By way of background information, the National Highway Traffic Safety Administration (NHTSA) does not approve, endorse, or certify motor vehicles or motor vehicle equipment. Under the National Traffic and Motor Vehicle Safety Act ("Safety Act"), the manufacturer is responsible for certifying that its vehicles or equipment comply with applicable Federal motor vehicle safety standards. The Safety Act requires that these safety standards establish minimum levels of performance for vehicles or equipment. Once the performance level has been established, vehicle or equipment manufacturers are free to choose any means they wish to achieve the required level of performance.
NHTSA has exercised its authority to establish performance requirements for new vehicles in Standard No. 111, Rearview Mirrors (49 CFR 571.111, copy enclosed). Standard No. 111 establishes performance and location requirements for rearview mirrors installed in any new vehicle. This means that the vehicle manufacturer must certify that each vehicle it manufactures complies with the specified requirements. Standard No. 111 requires that passenger cars be equipped with an inside rearview mirror and a driver's side outside rearview mirror that provide the field-of-view specified in S5.1.1. A passenger's side outside rearview mirror is required in situations where the inside rearview mirror does not provide the specified field-of-view. Additional requirements for other vehicle types are set forth in S6, S7, and S8.
No provision in the Standard specifies requirements for a mirror that attaches to the vehicle's rear bumper. Accordingly, a mirror like yours would not be prohibited from being installed on any vehicle by the current requirements in Standard No. 111. Accordingly such a mirror would be permitted, but only as a supplement to the required mirrors.
In installing the mirror, one must take care to avoid obscuring the vehicle's lighting devices, including the center highmounted stop lamps (CHMSL).
Please be aware that NHTSA does not regulate vehicles while they are in use. The American Association of Motor Vehicle Administrators, 4600 Washington Blvd, Arlington, VA 22203 may be able to advise you about the laws of the individual States related to the use of equipment such as your own.
I hope this information is helpful. If you have any further questions about NHTSA's safety standards, please feel free to contact Marvin Shaw of my staff at this address or by telephone at (202) 366-2992.
Sincerely,
Paul Jackson Rice Chief Counsel ref:111 d:8/7/92