Interpretation ID: aiam3781
316 Whitebirch
Wenatches
WA 98801;
Dear Mr. Brantner: This responds to your letter of November 9, 1983, to the Urban Mas Transit Administration, which was forwarded to this agency for reply, concerning legal requirements regulating window stickers. The following discussion addresses the Federal requirements applicable to sticker or other films applied to glazing materials in motor vehicles.; The National Highway Traffic Safety Administration has the authority t govern the manufacture of new motor vehicles and motor vehicle equipment. Pursuant to the National Traffic and Motor Vehicle Safety Act, we have promulgated Federal Motor Vehicle Safety Standard No. 205, *Glazing Materials*, which specifies performance and location requirements for glazing used in vehicles. These requirements include specifications for minimum levels of light transmittance (70 percent in areas requisite for driving visibility, which includes all windows in passenger cars) and abrasion resistance.; The agency has stated in past interpretations that films such as th type referred to in your letter are not glazing materials themselves, and would not have to comply with Standard No. 205. However, installation of such films on new motor vehicles would be prohibited if the vehicle glazing no longer complied with the light transmittance or abrasion requirements of the standard. If a vehicle manufacturer or a dealer places the film on glazing in a vehicle prior to sale of the vehicle, that manufacturer or dealer has to certify that the glazing continues to be in compliance with the requirements of Standard No. 205. Section 108(a)(1) prohibits any person from offering for sale or selling any motor vehicle or equipment that fails to comply with applicable safety standards.; After a new vehicle has been sold to the consumer, he may alter hi vehicle as he pleases, so long as he adheres to all State requirements. Under Federal law, the owner could install the film on glazing in his vehicle whether or not such installation adversely affected the light transmittance and abrasion resistance of his vehicle's glazing. It should be noted, however, that section 108(a)(2)(A) of the National Traffic and Motor Vehicle Safety Act provides that no manufacturer, distributor, dealer or motor vehicle repair business shall knowingly render inoperative any device or element of design installed on or in a motor vehicle in compliance with an applicable motor vehicle safety standard. 'Render inoperative' means to remove, disconnect or degrade the performance of a system or element of design installed pursuant to the Federal safety standards. Thus, none of those persons may knowingly install a film on a vehicle for its owner if that act would render inoperative the light transmittance or abrasion resistance of the vehicle glazing. Whether this would be the case would have to be determined by the person making the installation. Violation of this section can result in Federal civil penalties up to $1,000 for each violation.; Please contact Stephen Oesch of my staff if you have any furthe questions (202- 426-1834).; Sincerely, Frank Berndt, Chief Counsel