Interpretation ID: aiam3685
United States Senate
Washington
DC 20510;
Dear Senator Percy: This responds to your letter of April 11, 1983 (Ref. 3098500010 requesting information on behalf of your constituent, Mrs. D. Parutti. Mrs. Parutti is concerned about the growing practice of persons installing darkly tinted film on passenger car windows. She believes this is a dangerous practice because it prevents other drivers from seeing inside the vehicles. Following is a discussion of the implications under Federal law of installing these tinting films.; A Federal regulation already exists which, under certain circumstances precludes the practice referred to by Mrs. Parutti. The National Highway Traffic Safety Administration has the authority to govern the manufacture of new motor vehicles and motor vehicle equipment. Pursuant to the National Traffic and Motor Vehicle Safety Act, we have promulgated Federal Motor Vehicle Safety Standard No. 205, *Glazing Materials*, which specifies performance and location requirements for glazing used in vehicles. These requirements include specifications for minimum levels of light transmittance (70 percent in areas requisite for driving visibility, which includes all windows in passenger cars) and abrasion resistance. This specification for light transmittance precludes darkly-tinted windows in new automobiles.; The agency has stated in past interpretations that solar films such a the type referred to in Mrs. Parutti's letter are not glazing materials themselves, and would not have to comply with Standard No. 205. However, installation of such films on new motor vehicles would be prohibited if the vehicle glazing no longer complied with the light transmittance or abrasion requirements of the standard. If a vehicle manufacturer or a dealer places the film on glazing in a vehicle prior to sale of the vehicle, that manufacturer or dealer has to certify that the glazing continues to be in compliance with the requirements of Standard No. 205. Section 108(a)(1) prohibits any person from offering for sale or selling any motor vehicle or equipment that fails to comply with applicable safety standards.; After a new vehicle has been sold to the consumer, he may alter hi vehicle as he pleases, so long as he adheres to all State requirements. Under Federal law, the owner could install the tinting film on glazing in his vehicle whether or not such installation adversely affected the light transmittance and abrasion resistance of his vehicle's glazing. It should be noted, however, that section 108(a)(2)(A) of the National Traffic and Motor Vehicle Safety Act provides that no manufacturer, distributor, dealer or motor vehicle repair business shall knowingly render inoperative any device or element of design installed on or in a motor vehicle in compliance with an applicable motor vehicle safety standard. Render inoperative' means to remove, disconnect or degrade the performance of a system or element of design installed pursuant to the Federal safety standards. Thus, none of those persons may knowingly install a solar film on a vehicle for its owner if that act would render inoperative the light transmittance or abrasion resistance of the vehicle glazing. Whether this would be the case would have to be determined by the person making the installation. Violation of this section can result in Federal civil penalties up to $1,000 for each violation.; The individual States must govern the operational use of vehicles b their owners since the agency does not have authority in this area. Thus, it would be up to the States to preclude owners from applying films or one-way glass on their own vehicles. Mrs. Parutti may wish to contact the National Committee on Uniform Traffic Laws (555 Clark Street, Evanston, Illinois 60204) to find out which States have laws that would preclude owners from placing solar film on their automobile windows.; Please contact Hugh Oates of my staff if you have any further question (202- 426-2992).; Sincerely, Frank Berndt, Chief Counsel