Interpretation ID: aiam4998
CA 91601;
"Dear Mr. Kesler: This responds to your February 29, 1992 letter askin the agency to reconsider its decision to deny your earlier petition for rulemaking to amend Federal motor vehicle safety standard No. 111, Rearview Mirrors. As explained below, your request is again denied, for the same reasons explained in the previous denial. You initially petitioned the agency to amend Standard No. 111 to require passenger side convex mirrors to have a radius of curvature of 25 inches and to have a plastic label with a ring indicator applied to these mirrors. After reviewing the petition, the agency denied your request, finding that (1) a safety need for a wider field of view for passenger side convex mirrors had not been established and (2) your suggested mirror system would, by comparison with currently specified convex mirror systems, have increased distortion and reduced a driver's depth perception and judgment about another vehicle's closing speed. (56 FR 42715, August 29, 1991). In your February 29, 1992 correspondence, styled a 'petition for reconsideration,' you restated your previous request for the agency to amend Standard No. 111 to require a mirror with a 25 inch radius of curvature and a plastic label with a ring indicator applied to these mirrors. That request does not provide any new information beyond what was presented in your initial petition. Petitions for reconsideration may be filed only in response to an agency rule. See 49 CFR 553.35(a). A denial of a petition for rulemaking is not a rule, since such denials do not amend any existing provision in the Code of Federal Regulations. Thus, your correspondence is not a petition for reconsideration. It is possible that there might be instances in which additional information has become available since the agency considered and denied the initial petition for rulemaking. If such a situation were to arise, the petitioner could file a new petition for rulemaking, asking again for the requested action based upon the newly available information. NHTSA would consider this as a petition for rulemaking. As noted above, your correspondence did not provide any new information. Thus, your correspondence is not a petition for rulemaking. Instead, your correspondence is simply a request for NHTSA to take the same action you previously asked us to take in a petition for rulemaking. Absent any new information, there is no reason for NHTSA to reexamine its previous conclusion on this matter. I would like to take this opportunity to clarify what appears to be a misunderstanding of the agency's regulations on your part. In your February 29, 1992 correspondence, you made the statement that your product 'should be approved to be made available to the driver as an optional choice.' In our notice denying your petition, the agency tried to make clear that products like your convex mirror with a ring sensor label are not prohibited from being installed on vehicles by the current requirements in Standard No. 111. However, such mirrors are permitted only as supplements to the required mirrors, for the safety reasons explained at length in the denial notice. See 56 FR 42716, August 29, 1991. Hence, your product may be installed as a supplement to the required mirrors on current vehicles, without any amendments to Standard No. 111. I hope this information is helpful. If you have any further questions about NHTSA's safety standards, please feel free to contact Marvin Shaw of my staff at this address or by telephone at (202) 366-2992. Sincerely, Paul Jackson Rice Chief Counsel";