Interpretation ID: aiam3771
Member of Congress
4150 Cypress Road
St. Ann
MO 63074;
Dear Mr. Young: Thank you for your letter of October 13, 1983, concerning the potentia hazards posed to law enforcement officials by the use of opaque glass in automobiles. Through the exercise of its motor vehicle safety authority, the agency has addressed a part of this potential problem. However, given the limitations on the agency's authority, additional State action is needed to eliminate this potential problem.; Pursuant to the National Traffic and Motor Vehicle Safety Act, th agency has issued Federal Motor Vehicle Safety Standard No. 205, *Glazing Materials*, which specifies performance and location requirements for glazing used in vehicles. These requirements include specifications for minimum levels of light transmittance (70 percent in areas requisite for driving visibility, which includes all windows in passenger cars) and abrasion resistances. The specification for light transmittance precludes darkly-tinted windows in new automobiles.; In past interpretation letters, the agency has said that solar film an other materials used to make windows opaque are not glazing materials themselves and would not have to comply with Standard No. 205. However, installation of such films on new motor vehicles would be prohibited if the vehicle glazing no longer complied with the light transmittance of abrasion resistance requirements of the standard. If a manufacturer or a dealer places the film on glazing in a vehicle prior to the first sale of the vehicle, that manufacturer or dealer has to certify that the glazing continues to be in compliance with the requirements of Standard No. 205.; After a new vehicle has been sold to the consumer, he may alter th vehicle as he pleases, so long as he adheres to all State requirements. Under Federal law, the owner could install the tinting or other film on glazing in his vehicle whether or not the installation adversely affected the light transmittance and abrasion resistance of the glazing. Section 108(a)(2)(A) of the Vehicle Safety Act provides that no manufacturer, distributor, dealer or motor vehicle repair business shall knowingly render inoperative any device or element of design installed on or in a motor vehicle in compliance with an applicable motor vehicle safety standard. 'Render inoperative' means to remove, disconnect or degrade the performance of a system or element of design installed to comply with a Federal safety standard. Thus, none of those persons may knowingly install a tinting or other film on a vehicle for an owner if that action would render inoperative the light transmittance or abrasion resistance performance of the vehicle's glazing. Violation of the render inoperative provision can result in Federal civil penalties of up to $1,000 for each violation.; State law, rather than Federal law, governs the operational use o vehicles by their owners. Thus, it is up to the States to preclude owners from applying tinting or other films to their vehicle windows. A number of States have already adopted such laws. The agency would be glad to provide technical assistance on glazing requirements to the appropriate Missouri highway safety officials working on this problem.; I hope this explains the agency's authority to address the potentia problems posed by tinting and other films. If you need further information, the agency will be glad to provide it.; Sincerely, Diane K. Steed