Interpretation ID: aiam3448
Director
Automotive Safety Office
Environmental and Safety Engineering Staff
Ford Motor Company
The American Road
Dearborn
MI 48121;
Dear Mr. Maugh: This responds to your letter of July 31, 1981, to Hugh Oates of m staff requesting an interpretation concerning Safety Standard No. 210, *Seat Belt Assembly Anchorages*. You ask whether you are correct in your belief that the requirements of paragraph S4.3.1.1 of the standard apply to the seat belt anchorages used in your planned 1982-model Continental passenger cars rather than the requirements of paragraph S4.3.1.2.; Paragraph S4.3.1 of the Standard specifies location requirements fo the seat belt anchorages for Type 1 seat belt assemblies and the pelvic portion of Type 2 seat belt assemblies. Paragraph S4.3.1.1 applies in those installations in which the seat belt does not bear upon the seat frame, and the requirements of paragraph S4.3.1.2 apply in installations in which the seat belt does bear upon the seat frame. On the 1982 Continental passenger cars, the buckle end of the seat belt assembly passes through a 'console support structure' which is connected to the bottom of the seat frame. However, you contend that since the console support structure is not a structural component of the seat frame, the seat belt does not bear upon the seat frame and, consequently, that paragraph S4.3.1.1 applies.; Your interpretation of paragraphs S4.3.1.1 and S4.3.1.2 is correct. Th phrase 'bears upon the seat frame' as used in paragraph S4.3.1.2 refers to seat belt assemblies in which the seat belt presses or rests directly on the main structural frame of the seat. As illustrated in the photographs supplied in your letter, the seat belt in the 1982-model Continental passenger cars does not bear upon the structural seat frame. Rather, the belt rests on the console support frame which is not a necessary structural component of the main seat frame, but is merely attached to the seat frame at the bottom on the inboard side. Since the seat belt is located to the side of the seat frame and does not bear upon the structural seat frame itself, the requirements of paragraph S4.3.1.1 apply to the location of the seat belt anchorages used in the 1982 Continental passenger cars rather than the requirements of Paragraph S4.3.1.2.; We note that the console support frame could easily have been attache to the transmission tunnel rather than to the seat frame. In that case, the seat belt obviously would not bear upon the seat frame. However, with such a design, the frame supporting the belt would not move with the seat, and the driver could have problems reaching the belt and positioning it properly when the seat is in certain positions. The design of the passenger seat and seat belt assembly in the 1982 Continental is very desirable because attachment of the console support frame to the seat makes the seat belt very accessible in all seat positions. The fact that the console was attached to the seat frame for convenience purposes does not mean that the console is part of the seat frame within the meaning of S4.3.1.2.; The original intent of the location requirements of FMVSS 210 was t enhance belt performance with acceptable belt comfort and convenience. The specific requirements that are the subject of this interpretation were intended to ensure that belts would not develop excessive slack if a seat structural member bent or failed during a crash, and to reduce the likelihood that the lap belt would move into the abdominal area during a crash. We trust that Ford has adequately tested the configuration that is proposed here to ensure proper performance in a crash situation.; Please contact this office if you have further questions. Sincerely, Frank Berndt, Chief Counsel