Interpretation ID: aiam4948
Director Automotive Safety Engineering Environmental Activities Staff General Motors Corporation General Motors Technical Center 30400 Mound Road Warren
MI 48090-9015;
"Dear Mr. Rogers: This responds to your request that this agenc determine that the new antitheft device to be installed on the MY 1992 General Motors Pontiac Bonneville line, represents a de minimis change in the system that was the basis for the agency's previous granting of a theft exemption for the car line beginning in MY 1991, and that therefore the Pontiac Bonneville vehicles containing the new device would be fully covered by that exemption. The agency has reviewed the changes to the system and for the following reasons concludes that the differences between the original system and one installed on the MY 1992 Pontiac Bonneville constitute a de minimis change. As you are aware, the Pontiac Bonneville car line was granted an exemption, pursuant to 49 CFR Part 543, from antitheft marking because General Motors showed that the antitheft device to be used in lieu of marking on the car line was likely to be as effective as parts marking. This antitheft device is known as the 'PASS-KEY' antitheft system. The exemption was issued on April 4, 1991, and appeared in the Federal Register on April 9, 1991 (56 FR 14413). As was stated in the April 1991 Federal Register notice, the 'PASS-KEY' antitheft system utilizes an ignition key, an ignition lock cylinder and a decoder module. Before a vehicle can be started, the electrical resistance of a pellet embedded in the shank of the key must be sensed by elements in the lock cylinder and its value compared to a fixed resistance in the decoder module. In your letter, it was stated that beginning from MY 1992, two design changes were made in the 'PASS-KEY' antitheft device that is standard equipment on the Pontiac Bonneville. The new system on the Bonneville is known as 'PASS-KEY II,' and differs from 'PASS-KEY' as follows. First, in 'PASS-KEY II,' if a key other than the one with proper resistance for the vehicle is inserted, the decoder module will shut down the fuel injector pulses to the engine for three minutes plus or minus eighteen seconds. In 'PASS-KEY,' this shut down period is two to four minutes. Second, if, during the time the decoder module has shut down in 'PASS-KEY II,' trial and error attempts are made to start the engine with various keys, the timer will not reset to zero, as is the case with 'PASS-KEY.' GM states that this difference in functions will provide a similar level of performance as 'PASS-KEY' since the 'PASS-KEY II' module, while shut down, will ignore further attempts to start the system by means other than use of a key with the proper resistance pellet. Any further unauthorized attempt after the initial three minute shut down time will result in the module shutting down again. After reviewing the proposed changes to the componentry and performance of the antitheft device on which the exemption was based, the agency concludes that the changes are de minimis. In addition to providing some aspects of performance not provided by the original device, 'PASS-KEY II' also continues to provide the same aspects of performance provided by the original device and relies on essentially the same componentry to provide that performance. Therefore, it is not necessary for General Motors to submit a petition to modify the exemption pursuant to 49 CFR Part 543.9(c)(2). If General Motors does not implement the new antitheft device as described in your letter for MY 1992, we request that this agency be notified of such decisions. Sincerely, Barry Felrice Associate Administrator for Rulemaking /";