Interpretation ID: aiam4548
Inc. PO Box 3698 Terminal Annex Los Angeles
CA 90051;
"Dear Mr. Ceazan: This is in response to your letter asking whethe tires marked with both an ETRTO (European Tyre and Rim Technical Organization) size designation and a different ISO (International Standardization Organization) size designation can legally be imported into the United States. As discussed below, such tires cannot be imported into the United States, because they do not comply with the applicable safety standards. I regret the delay in this response. All new pneumatic tires imported into the United States for use on passenger cars must be certified as complying with Federal Motor Vehicle Safety Standard No. 109, New Pneumatic Tires - Passenger Cars (49 CFR /571.109), and all new pneumatic tires imported for use on motor vehicles other than passenger vehicles must be certified as complying with Standard No. 119, New Pneumatic Tires for Vehicles Other Than Passenger Cars (49 CFR /571.119). Both of these standards prohibit 'dual-size markings,' or labeling two different size designations on one tire. In the case of passenger car tires, section S4.3(a) of Standard No. 109 specifies that each tire shall be labeled with 'one size designation, except that equivalent inch and metric size designations may be used.' (emphasis added). This agency expressly prohibited dual-size markings on passenger car tires in a preamble amending Standard No. 109, 36 FR 1195, January 26, 1971. This prohibition was expressly repeated in subsequent amendments that addressed the question of tire labeling under Standard No. 109, see 39 FR 10162, March 18, 1974, and 42 FR 12869, March 7, 1977. In the case of tires for use on vehicles other than passenger cars, there is no express prohibition in Standard No. 119 against dual size markings. However, section S6.5(c) of Standard No. 119 requires that each tire be marked on both sidewalls with 'the tire and size designation as listed in the documents and publications designated in S5.1.' NHTSA has interpreted the use of the singular in the phrase 'tire size designation,' rather than the plural 'tire size designations,' to be a prohibition against marking more than one tire size designation on these tires. See the enclosed copies of my January 7, 1988 letter to Mr. E.W. Dahl and my February 16, 1988 letter to Mr. Mike Kaizaki. Since tires marked with two size designations would not comply with our tire standards, they could not legally be imported into the United States, according to the requirement specified in section 108(a)(1)(A) of the National Traffic and Motor Vehicle Safety Act (15 U.S.C. 1397(a)(1)(A)). If you have any further questions about our tire standards or need additional information on this subject, please feel free to contact Mr. Marvin Shaw of my staff at this address or by telephone at (202) 366-2992. Sincerely, Erika Z. Jones Chief Counsel Enclosures /";