Pasar al contenido principal
Search Interpretations

Interpretation ID: aiam2218

Georgette A. Sears, Route 2, Box 133c, Keymar, Maryland 21757; Georgette A. Sears
Route 2
Box 133c
Keymar
Maryland 21757;

Dear Ms. Sears: This is in response to your letter of January 6, 1976, requestin information as to the Federal Standards and regulations that are applicable to the manufacture of an '18 inch pull type horse/stock trailer combination.'; Manufacturers of trailers of the type you describe must certify tha their product is in compliance with Federal Motor Vehicle Safety Standard No. 108, *Lamps, reflective Devices, and Associated Equipment*, 49 CFR 571.108, and Standard No. 120, *Tire Selections and Rims for Vehicles Other Than Passenger Cars, 40 CFR 571.120. Please note, however, that Standard No. 120 is not effective until August 1, 1976, for the rim marking requirements (S5.2), and September 1, 1976, for the remaining requirements, so trailers manufactured before these times will not have to be certified as being in compliance with Standard No. 120.; The procedure for certification is specified in 49 CFR Part 567, an requires the manufacturer to affix a label to his product certifying that it is in compliance with the requirements of applicable Federal regulations. You should check the trailer that you purchase to make certain there is a certification label. Part 567.4(d) specifies that the certification label for trailers shall be affixed to a location on the forward half of the left side, such that it is easily readable from outside the vehicle without moving any part of the vehicle.; There are no Federal regulations concerning the connection of trailer to trucks or other vehicles. Nevertheless, from a safety stand point it is important that you ascertain the hauling capacity of your truck-trailer system in order to avoid overloading that could create potential safety hazards. You should obtain information from the manufacturer concerning the 'tongue weight' of the trailer when fully loaded, and relate it to the gross axle wight ratings of your towing vehicle, found on its certification label on the door or door post. The trailer manufacturer may also have further recommendations as to the capacity of the vehicle needed to tow one of his trailers safely.; Please contact us if we can be(sic) of any further assistance. Yours truly, Richard B. Dyson, Assistant Chief Counsel