Interpretation ID: aiam3235
Director
Vehicle Safety Programs
American Motors Corporation
14250 Plymouth Road
Detroit
MI 48232;
Dear Mr. Jones: This responds to your letter of January 14, 1980, requesting a interpretation concerning the proper designated seating capacity for the front seats of the 1981-model AMC Concord. Your letter states that the Concord front seats have over 50 inches of hip room as measured by SAE procedure J1100a, but you characterize the seats as 'individual' seats since they are separately adjustable. You ask whether the seats can qualify as having only two designated seating positions.; Based upon the information in your letter and on the photographs yo submitted February 22, it is our opinion that there must be three front designated seating positions in the 1981 AMC Concord. The amended definition of 'designated seating position' provides that there shall be at least three positions in any bench or split-bench seat having greater than 50 inches of hip room, unless there is some obstruction or design preventing use of the center position. Although the seats in this model are on separate tracks and are separately adjustable, they are the functional equivalent of a split bench seat when the two sections are side-by side (as illustrated in your Number One photograph). There is not sufficient space between the seats for them to qualify as separate bucket seats. Bucket seats are typically separated by at least 8 to 10 inches. The juxtaposition and design of these 'individual' seats creates a well-padded center position. Further, although the inboard buckle portion of the seat belt assemblies occupy the center position, the buckles can be easily pushed down between the seats and would not be an impediment to use of the center position (as illustrated in your photograph Number Three).; For these 'individual' seats to qualify as having only two designate seating positions, it is our opinion that they would have to be much further apart, as is true of typical bucket seats, since they currently provide over 50 inches of hip room. Alternatively, the buckle ends of the seat belt assemblies would have to be on much stiffer cables that could not be moved out of the way or pushed between the seats. Moreover, these buckle ends must extend far enough onto the seat to provide true obstructions to use of the center position.; Finally, I would emphasize that this letter only represents th agency's opinion based on the information supplied in your submissions. The NHTSA does not pass approval on any vehicle design, for any safety standards, prior to the actual events that underlie certification. It is up to the manufacturer to determine whether its vehicles comply with all applicable safety standards and regulations, and to certify the vehicles in accordance with that determination.; Sincerely, Frank Berndt, Chief Counsel