Interpretation ID: aiam1228
Manager
Electrical Testing Laboratories
Inc.
2 East End Avenue
New York
NY 10021;
Dear Mr. Robb: This is in reply to your letter of June 18, 1973, concerning th conformity of certain designs of type III seat belt assemblies with Standard No. 209.; The first feature which you describe is a restraint consisting of waist band with a single shoulder strap. The shoulder strap is attached to the buckle in front and is looped around the waist band in back. Unless this restraint has more elements than you describe, we have serious questions about its conformity with the requirements for type III seat belts under Standard 209. Section S4.1(c) provides that the assembly must restrain the upper torso without shifting the pelvic restraint into the abdominal region and that the upper torso restraint shall be designed to minimize its vertical forces on the shoulders and spine. It appears doubtful that the described assembly meets either of these requirements.; The second feature you describe is a strap through the harness assembl that passes around the seat back and is anchored to the floor by means of the vehicle's seat belt assembly anchorage. Your question appears to be whether such a restraint is a seat back retainer as required by Section S4.1(h). The attachment you describe would not be a seat back retainer under Section S4.1(h).; The third feature described, a closed loop strap without floo attachment would also violate the requirements of S4.1(h), unless it is designed and labeled for use only in specific models having adequate seat back restraints, as specified in that paragraph.; The fourth feature is the ability of a harness to move freely up an down on the restraint strap. This feature is allowable under Standard 209.; Yours truly, Richard B. Dyson, Assistant Chief Counsel