Pasar al contenido principal
Search Interpretations

Interpretation ID: aiam3202

Mr. J. Kawano, General Manager, U.S. Representative Office, Toyota Motor Co., Ltd., One Harmon Plaza, Secaucus, NJ 07094; Mr. J. Kawano
General Manager
U.S. Representative Office
Toyota Motor Co.
Ltd.
One Harmon Plaza
Secaucus
NJ 07094;

Dear Mr. Kawano: This responds to your recent request for an interpretation concernin the proper designated seating capacity for the rear seat in several Toyota vehicle models (Corolla Sedan, Corolla Coupe, Corona Sedan and Starlet). You assert that the rear seat hip room in these models ranges from 39.4 inches to 42.6 inches, and ask whether the vehicles would qualify as having only two designated seating positions.; Under the strict measurement technique specified in the amende definition of 'designated seating position' (SAE J1100a), the Toyota vehicle models in question would have the hip room dimensions you state. This is due to the fact that the SAE procedure specifies that hip room is to be the minimum dimension of the seat cushion. The Toyota designs include wheel wells and contoured side paddings at the intersection of the seat back and seat cushion that establish the minimum dimension of the seat. However, these structures only extend out 4 to 5 inches (approximation) from the seat back. If the hip room of the rear seats is measured midway of the seat cushion, all of the designs have greater than 50 inches of hip room, and ostensibly should have three designated seating positions. Nevertheless, since according to the measurement technique specified in the definition these seats have substantially less than 50 inches of hip room, the agency must conclude that the rear seats could qualify as having only two designated seating positions. This opinion is accompanied with several candid remarks, however.; The effective hip room of the Toyota seat designs is much greater tha the approximately 40 inches that is obtained by the technical measuring technique specified in the definition. If two outboard occupants move their hips several inches forward from the seat back in these vehicle designs, the wheel-wells and contoured side paddings are no longer impediments and there is over 50 inches of hip room, as noted above. Moreover, the design of these rear seats is such that use of the center position is 'invited.' There is at least 10 to 12 inches of well-padded hip room at the center portion of the seat between the inboard ends of the two seat belt assemblies installed in the seats. The manufacturer has given no indication that this space is not intended for occupancy. The agency is also concerned that this center position has no belt assembly to secure a child restraint system, particularly since the rear- center seat is statistically the safest position in a vehicle.; Frankly, with the wide center space that is available in these rea seat designs, we do not believe the manufacturer has made a sincere attempt to indicate to vehicle occupants that the seats are intended for use by only two occupants. It would be a simple matter for the manufacturer to make this obvious by use of a fixed armrest or some other impediment to use of the position. Furthermore, we believe that this message can be given to occupants without otherwise compromising the design the manufacturer wishes to achieve. If the manufacturer does not in fact wish to market the vehicles as having three-passenger rear seats, we do not understand why wide, well-padded center positions are present.; Finally, I am enclosing a copy of an earlier interpretation whic discusses the measurement procedure included in the definition of 'designated seating position.' As that interpretation pointed out, the agency will not allow manufacturers to avoid the obvious intent of the definition by finding 'loopholes' in the specified measurement procedure. If designs such as those displayed in the Toyota vehicles persist, without some clear indication that the center position is not to be used, the agency may find it necessary to amend the definition to provide that the hip room measurement is to be taken at the midpoint of the seat cushion. We hope that manufacturers will voluntarily alter designs of this type to conform to the intent of the definition, so that such an amendment is not necessary.; Sincerely, Frank Berndt, Chief Counsel