Interpretation ID: 1984-1.10

TYPE: INTERPRETATION-NHTSA

DATE: 02/07/84

FROM: AUTHOR UNAVAILABLE; Frank Berndt; NHTSA

TO: Mr. Rod L. Stafford Fryford Corporation

TITLE: FMVSS INTERPRETATION

TEXT: This responds to your recent letter requesting information on which of the agency's regulations would apply to a new product you are considering. You described the product as a "hammock-like seat which, unrolled and fastened into the rear bed of any pickup truck, forms a comfortable passenger seat which may be easily stowed inside the truck cab." You stated that you plan to sell your product as an item of aftermarket equipment and asked about the application of our regulations to your product.

If your product is sold as an item of aftermarket equipment to be installed by a vehicle owner, it would not be required to comply with Standards Nos. 207, 208, 209, 210, and 302. We were pleased to learn that you have nevertheless voluntarily designed your product to conform to those standards.

As a manufacturer of an item of motor vehicle equipment, you do have a responsibility under section 151 et seq. of the National Traffic and Motor Vehicle Safety Act to conduct a notification and remedy campaign if you or the agency determines that your product contains a safety-related defect or does not comply with an applicable standard. A copy of the Act is enclosed.

If you have any further questions, please let me know.

Sincerely,

Enclosure

ATTACH.

WILLIAM SMITH -- Office of the Chief Council, National Traffic & Highway Safety Administration

Mr. Smith,

We are a manufacturer of an aftermarket product with the trade name "2nd Seat," and this letter regards the applicability of Federal Motor Vehicle Standards to our product.

The "2nd Seat" is essentially a hammock-like seat which, when unrolled and fastened into the rear bed of any pickup truck, forms a comfortable passenger seat which may be easily stowed inside the truck cab. The seat is designed to be installed in a rearward-facing attitude, and the rider position is recumbent with an upper body angle which is reclined more than 45 degrees from the vertical axis. The width of the bench thus formed is 45".

We have designed our product to conform to the requirements set forth in Sec. 207 thru 210 of the motor vehicle codes, and the Sec. 302 which refers to Fire Retardant standards. We have performed an engineering study which indicates that our product exceeds the requirements for both the strength of the seat body, and the safety restraint system. However, we understand that the standards are not specifically directed at the aftermarket and that compliance on our part may therefore be subject to a specific ruling from your Department.

If you require more detailed information about the "2nd Seat" or if there is a customary posture which the Administration generally assumes in such cases, please inform us at your earliest convenience.

Sincerely,

Rod L. Stafford -- Fryford Corporation