Interpretation ID: 22137(2)

Bob Snyder, Vice President
Longacre and Associates, Inc.
424 Fourth Street
Suite C
Annapolis, MD 21403

This responds to your August 24, 2000, letter asking whether vehicles are allowed to have any size side windows in the front seat occupant compartment. Specifically, you ask about the requirements of Federal Motor Vehicle Safety Standard (FMVSS) No. 205, Glazing materials (49 CFR 571.205) and FMVSS No. 214, Side door strength (49 CFR 571.214), as applied to a flatbed-type truck with a gross vehicle weight rating of 18,000 pounds. Our answer is that our standards do not directly limit the size of vehicle side windows.

By way of background information, the National Highway Traffic Safety Administration (NHTSA) has the authority to issue FMVSSs applicable to new motor vehicles and new items of motor vehicle equipment. Federal law establishes a self-certification system under which motor vehicle and equipment manufacturers themselves certify that their products comply with all applicable standards. For that reason, NHTSA neither tests, approves, disapproves, nor endorses products prior to their introduction into the retail market. Rather, we enforce compliance with the standards by purchasing new vehicles and equipment and testing them. We also investigate safety-related defects.

Our FMVSSs set forth requirements for safety performance, in terms that minimize design restrictions. Ejection of occupants through glazing (through windshields or the side windows) is a safety concern addressed by several standards, including FMVSS No. 205. FMVSS No. 205 sets performance requirements for glazing materials used in new motor vehicles and glazing materials sold as items of replacement equipment. FMVSS No. 212, Windshield mounting (49 CFR 571.212), establishes windshield retention requirements to reduce the likelihood of ejection of occupants in a crash. FMVSS No. 217, Bus emergency exits and window retention and release (49 CFR 571.217), establishes requirements for the retention of windows in buses, to minimize the likelihood of occupants being thrown from the bus.

You also inquire about the requirements of FMVSS No. 214. FMVSS No. 214 specifies vehicle crashworthiness requirements in terms of accelerations measured on anthropomorphic dummies in test crashes and specified strength requirements for side doors. FMVSS No. 214 does not apply to trucks with a gross vehicle weight rating of 18,000 pounds.

At this time, the above-discussed standards do not directly restrict the size of side windows. NHTSA, however, in response to the NHTSA Authorization Act of 1991 and ongoing research into rollover and ejection mitigation, is currently evaluating the potential of advanced glazing systems to reduce occupant ejection. The agency has recently published a report entitled "Ejection Mitigation Using Advanced Glazing: Status Report II" which evaluates the progress of that advanced glazing research. This report is available online at http://www-nrd.nhtsa.dot.gov/include/nrd10/nrd11/glazing.html or may be ordered through NHTSA's Technical Information Services at 1-800-445-0197.

I note that the Department's Federal Motor Carrier Safety Administration (FMCSA) has jurisdiction over interstate motor carriers operating in the United States. FMCSA was established on January 1, 2000, and was formerly a part of the Federal Highway Administration (FHWA). You may wish to contact the FMCSA at (202) 366-4012 for information concerning the issues discussed in your correspondence.

I hope this information is helpful. If you have any questions or need additional information, feel free to contact Nancy Bell of my staff at (202) 366-2992.

Sincerely,

Frank Seales, Jr.
Chief Counsel

ref:205
d.1/3/01