Interpretation ID: 2416y
Vice President
The Goodyear Tire & Rubber Company
Akron, Ohio 44316-0001
Dear Mr. Dahl:
This responds to your letter seeking an interpretation of 49 CFR 574, Tire Identification and Recordkeeping. Specifically, you asked whether an additional symbol, which is intended to identify more precisely the year of manufacturer, is permitted to be included in the tire identification number. As explained below, the answer is yes.
The purpose of the tire identification requirements is to facilitate the effective recall of tires from the public if the tires are found not to comply with the applicable safety standards or if the tires contain a safety related defect. Section 574.5 requires that each tire be marked with the tire identification number. In particular, it requires that the fourth grouping contain three numerals of which the first two identify the week of the year and the third numeral identifies the year of manufacture. You believe that this requirement may lead to confusion because the third numeral, e.g. "9", could refer to more than one year, e.g., 1979 or 1989. Accordingly, you state that your company would like to be able to distinguish the year of manufacture in an interval longer than one decade. To do this, you would like to add a symbol immediately following the fourth grouping of the tire identification number to identify that this tire was produced in the decade 1990 through 1999.
Standard No. 109, New pneumatic tires (49 CFR 571.109) and Standard No. 119, New pneumatic tires for vehicles other than passenger cars (49 CFR 571.119) together with Part 574 require that certain information be labeled on the sidewalls of each tire subject to the standards. In a May 31, 1988 letter to Mr. Garry Gallagher of Metzeler Motorcycle Tire (copy attached), the agency explained that
The agency has frequently stated in past interpretations that the purpose of these labeling requirements is to provide the consumer, in a clear and straightforward manner, with technical information necessary for the safe use of the tires. [These standards] permit tire manufacturers to label additional information on the sidewall on the tires, provided that the additional information does not obscure or confuse the meaning of the required information, or otherwise defeat its purpose.
Applying this standard to the question you have asked, we believe that the additional symbol, an isosceles right triangle, is not prohibited from appearing on the sidewall of your company's tires. As explained above, the labeling requirements are intended to provide information about the tire, including the year of manufacture, in a clear and straightforward manner. Because the suggested symbol does not appear to introduce additional information that might obscure or confuse the meaning of the required information or otherwise defeat its purpose, the agency has determined that marking a tire with an isosceles right triangle after the tire identification code is not prohibited.
Sincerely,
Stephen P. Wood Acting Chief Counsel ref:574 d:5/2/90