Pasar al contenido principal
Search Interpretations

Interpretation ID: 2983yy

Mr. Takeo Wakamatsu
Executive Vice President and
General Manager
Mitsubishi Motors America, Inc.
Bridgeport Office
100 Center Square Road
P.O. Box 464
Bridgeport, NJ 08014

Dear Mr. Wakamatsu:

This responds to your March 28, 1991, letter to Mr. Scott Shadle of this agency's Rulemaking office, on behalf of Mitsubishi Motors Corporation (MMC) in Japan. MMC requests approval of its plan for "derating" the gross vehicle weight rating (GVWR) of certain imported trucks for the purpose of marketing strategy. Based on the context of the letter, I presume that you mean that MMC would like to lower the GVWR of the vehicles. The following responds to this request.

NHTSA is not authorized by the National Traffic and Motor Vehicle Safety Act to certify or approve motor vehicles or motor vehicle equipment for compliance with the Federal Motor Vehicle Safety Standards (FMVSS). Each manufacturer is responsible for certifying that its products meet all applicable safety standards.

The GVWR assigned to a vehicle by its manufacturer affects the vehicle's loading and other test conditions to which the vehicle will be subjected during NHTSA's compliance testing for the vehicle. Generally, NHTSA expects the GVWR to reflect a manufacturer's good-faith evaluation of the vehicle's size, weight, and load carrying capacity. The only regulatory limitation on the GVWR that manufacturers may assign to their vehicles is set forth in 49 CFR Part 567, Certification. Section 567.4(g)(3) provides that the assigned GVWR "shall not be less than the sum of the unloaded vehicle weight, rated cargo load, and 150 pounds times the vehicle's designated seating capacity."

There is no regulatory prohibition against a manufacturer lowering the GVWR assigned to its vehicles. Of course, the lower GVWR would have to be not less than the minimum GVWR specified in 567.4(g)(3). Further, the certification label on the vehicle would have to show the lowered GVWR as the GVWR assigned to the vehicle. In addition, the manufacturer must reexamine its certification of compliance for the vehicle to ensure that the vehicle continues to comply with all safety standards at this new lower GVWR, and that the vehicle continues to comply with all other NHTSA regulations (such as 49 CFR Part 565, Vehicle Identification Number-Content Requirements) at the lower GVWR. Assuming these conditions would be satisfied, MMC would be permitted to lower the GVWR assigned to these vehicles.

I hope that this information is helpful. Please feel free to contact us if you have any further questions.

Sincerely,

Paul Jackson Rice Chief Counsel

ref:567 d:4/29/9l