Interpretation ID: 3238yy
Project Manager, Energy and Processing
Prairie Agricultural Machinery Institute
P.O. Box 1150
Humboldt, Saskatchewan S0K 2A0
Canada
Dear Mr. Lischynski:
This responds to your letter of October 3, 1991 concerning Calmar Industries' Seat Lift Kit for Ford Supercab trucks. As described by you, the "Seat Lift Kit is an attachment to raise the rear bench seat in Ford Supercab trucks. The kit does not alter the factory seat, and uses the factory seat belts. However, the seat mounts are changed, and an extension is provided to raise the seat belt attachment point." You asked which safety standards this kit must meet.
The National Highway Traffic Safety Administration has issued one safety standard that applies to seats, Standard No. 207, Seating Systems, and the following safety standards that apply to safety belts: Standard No. 208, Occupant Crash Protection, Standard No. 209, Seat Belt Assemblies, and Standard No. 210, Seat Belt Assembly Anchorages. All safety belts sold in the United States must be certified as complying with Standard No. 209, regardless of whether the belts are installed as original equipment in a motor vehicle or sold as a replacement part. However, since you indicate that the kit uses the factory-installed safety belts, it does not appear that you need to be concerned with this standard.
Since Standard No. 207, Standard No. 208 and Standard No. 210 apply only to new vehicles, they are called vehicle standards. The National Traffic and Motor Vehicle Safety Act specifies that vehicles must conform with all applicable safety standards up until the first purchase for purposes other than resale. Therefore, if the seat lift kit is installed in a truck before its sale to its first purchaser, the vehicle with the lift kit installed must conform to these standards.
After the first purchase, the vehicle is no longer required by Federal law to conform with all safety standards. However, section 108(a)(2)(A) of the Safety Act provides as follows:
No manufacturer, distributor, dealer, or motor vehicle repair business shall knowingly render inoperative, in whole or part, any device or element of design installed on or in a motor vehicle or item of motor vehicle equipment in compliance with an applicable Federal motor vehicle safety standard . . . .
In order to avoid violating this provision, a manufacturer, dealer, distributor, or repair business which installed the lift kit would need to ensure, by carefully comparing the lift kit and its planned installation with the requirements of relevant safety standards, that such installation enables the vehicle to continue to comply with all applicable safety standards. Violations of 108(a)(2)(A) are punishable by civil fines of up to $1,000 per violation. I note that section 108(a)(2)(A) does not affect modifications made by vehicle owners to their own vehicles.
I hope you find this information helpful. If you have further questions, please contact Mary Versailles of my staff at this address or by telephone at (202) 366-2992.
Sincerely,
Paul Jackson Rice Chief Counsel
/ref:VSA#207#208#209#210 d:l2/4/9l